Filter
Top Products
H 100
C 414 B/TLII
Condenser Microphone
Description
There are probably more AKG C 414 microphones in
studios worldwide than any other 1-inch condenser multi-
pattern microphone model from any manufacturer. The
reasons are numerous: these microphones are workhorses in
all areas of recording, from the pop studio to classical
recording venues. Their variety of polar patterns, along with
two degress of bass cut and two levels of padding, make
them ideal for recording just about any vocal or instrument
under any conceivable working condition in the studio.
The AKG C 414 B/TLII is the latest of a series of variations
on the basic C 414 design and draws from AKG’s early
studio heritage, the legendary Model C 12. The CK 12 dual
diaphragm capsule has been recreated, with its combination
of warmth and presence, and combined with modern
solidstate transformerless circuitry. The early CK 12’s were all
slightly different in response -- a consequence of individual
hand-crafting. Today we bring a higher degree of uniformity
to the production line, and the new C 414 B/TLII models are
quite consistent in response. Also, an H 100 spider
suspension shock mount and W 414 windscreen are included
as standard accessories.
Features
• One of the world’s most popular
studio 1-inch condenser
microphones
• Response patterned after the AKG
classic C 12 microphone
• Four selectable polar patterns
(omni, cardioid, hypercardioid and
figure-eight)
• Operates with phantom powering
from 12 to 48 volts nominal
• Broad response rise in the 3 kHz
range enhances vocal presence in
the studio
• Includes an H 100 isolation shock
mount and W 414 windscreen
Specifications
Transducer type: Dual diaphragm, 1 in. (25 mm) diameter
pressure gradient
Diaphragm material: Gold-sputtered mylar foil
Frequency response: 20 Hz - 20 kHz (+1.5/-1.0 dB)
Polar patterns: Omnidirectional, cardioid,
hypercardioid and figure-eight
Impedance: 180 ohms
Recommended load impedance: greater than 600 ohms
Output connector: XLR (pin 2 positive, per IEC standard)
Sensitivity at 1 kHz: 12.5 mV/Pa; -38 dB (dB re 1 V)
Equivalent noise level (A-weighted): 14 dB (DIN 45412)
Sound pressure level for 0.5% THD: 140 dB (160 dB SPL with
-20 dB preattenuation)
30 Hz - 20 kHz
S/N ratio re 1 Pa (A-weighted): 80 dB
Environmental:
Operating temperature: 14° F to 140° F (-10°C to + 60°C)
Relative humidity: 90% (+20°C), 85% (60°C)
Pre-attenuation switch: -10 or -20 dB
Low frequency roll-off: 12 dB/octave below 75 or 150 Hz
Power requirement: 12 to 48 V phantom power nominal
Current consumption: less than 2 mA
Microphone size: 5.6” x 1.8” x 1.4”
(141 mm x 45 mm x 35 mm)
Microphone net weight:11 oz. (0.31 kg)
Shipping weight: 33.6 oz. (0.97 kg)
Standard accessories: H100 Spider shock mount
W414 Foam windscreen
Optional Accessory: SA18/3B Stand adapter