AmpliVox S500-OK DJ Equipment User Manual


 
SOUND COLUMN LECTERN
PUBLIC ADDRESS SYSTEM
MODEL S500-MH/MO/OK/WT
INCLUDES:
New S805A Multimedia Stereo Amplifier
Professional Cardioid Microphone
Gooseneck Microphone holder
Built in Speakers
Removable Dual Speaker Module [S1201]
SET UP:
INSTALL POWER SUPPLY
Battery pack is standard. Optional Power Supplies may be substituted. Model S1460,
International AC Adapter/Recharger (110/220V, 50/60Hz). Model S1462, 12 Volt DC adapter
(automotive cigarette lighter plug-in). S1465 NiCad Battery Pack.
TO INSTALL OR REPLACE BATTERIES
Remove all plugs from amplifier. Remove amplifier from lectern. Slip fingernail under battery
door on back of amplifier and slide out. Remove battery pack from amplifier. Insert 10 new
Alkaline “D” cell batteries, be sure to observe polarity, or replace with S1465 NiCad battery
pack. Carefully replace battery pack. Slide battery door back into position. Place amplifier in
lectern.
Do not mix battery types or attempt to recharge alkaline batteries - equipment damage, safety
hazard or fire could result.
TO OPERATE:
Plug microphone into DYNAMIC Microphone jack.
Plug straight end of 12” speaker cable into built in speaker jack and right angle end into left
SPEAKER jack on amplifier. Plug straight end of 40’ speaker cable into jack on removable
speaker module and right angle end into right SPEAKER jack on amplifier.
Turn Amplifier on (switch is located on the front of the amplifier). The red light will go on,
showing that power is available. Rotate VOLUME control knob to obtain desired loudness level
throughout the coverage area.
ON-OFF
When switch is in the ON position, the red light will be on.
DC IN
Connection for optional adapter:
S1460 Universal AC Adapter (110/220V, 50/60Hz) / NiCad Battery Recharger
S1462 12 Volt DC (automotive cigarette lighter) Adapter