Filter
Top Products
CONTENTS
GETTING STARTED - WARRANTY INFORMATION .................................................................................................. 2
SETTING UP YOUR XTREME SOUND SYSTEM ......................................................................................................... 2
FEEDBACK - CONNECTING XTREME SOUND SYSTEMS - SPEAKER STAND SETUP ................................................ 3
SOUND SYSTEM ACCESSORIES ............................................................................................................................... 4
XTREME SOUND SYSTEM BASIC OPERATION ...................................................................................................... 4/5
OPERATING THE BUILT-IN UHF WIRELESS RECEIVER ........................................................................................... 6
OPERATING THE BUILT-IN CD PLAYER .................................................................................................................. 6
OPERATING THE WIRELESS MICROPHONE/TRANSMITTER ................................................................................... 7
HAVING TROUBLE W/ YOUR SOUND SYSTEM? ...................................................................................................... 8
XTREME TECHNICAL SPECIFICATIONS .................................................................................................................... 8
HAVING TROUBLE W/ YOUR SOUND SYSTEM?
CONDITION POSSIBLE CAUSE
No Sound (power LED = OFF) • power switch is in OFF position
• blown fuse
No Sound (power LED = ON) • no output from source
• input cable unplugged
• input volume control low or off
• accessory or expansion module not in option bay
Distorted Sound • poor or improper connection on input cable
• input signal too strong
Excessive Hum or Noise • input cable not shielded
• not using balanced microphone
HAVING TROUBLE W/ YOUR WIRELESS SYSTEM? (Wireless Models Only)
CONDITION POSSIBLE CAUSE
No Sound (TX ON indicator lights) • wireless volume control low or off
• no mic plugged into belt-pack transmitter
No Sound (TX ON indicator off) • sound system not turned on
• transmitter power switch turned off
• low battery or no battery in transmitter
Anchor Audio, Inc.
Portable Sound Systems • Torrance, California
100-0135-000/B- 10/06
OWNER’S MANUAL
Xtreme
Portable Sound System
Anchor Audio Customer Service
888-444-6077
XTREME TECHNICAL SPECIFICATIONS
Rated Power Output stand-alone w/ XTR-6001 companion
Low Frequency Amp 90 watts 125 watts
High Frequency Amp 40 watts 55 watts
Max SPL@Rated Power 116 dB (speech projection = off)
123 dB (speech projection = on)
General
Frequency Response 80 Hz - 15 kHz (speech = off)
+7 dB from 2 -12 kHz (speech = on)
Bass/Treble Control 8 dB cut/boost @ 100 Hz, 8 kHz
Inputs
Line Input 1/4” phone, Hi-Z, unbalanced
Mic Input XLR, Lo-Z +12VDC condenser mic power
Balanced Input XLR, switchable mic/line level
+12VDC condenser mic power
Sensitivity For Rated Output
Unbalanced Line -18 dBV / 125 mVrms
Balanced Mic -58 dBV / 1.25 mVrms
Balanced Mic Input -58 dBV / 1.25 mVrms
Balanced Line Input -15 dBV / 175 mVrms
Outputs
Line Output (post fader) XLR male, 600 ohm, active balanced
Speaker Output 4-pole Neutrik Speakon®jack
use w/ Anchor XTR-6001
AC Power Requirements 110 - 125 VAC, 50/60 Hz, 250 watts max
210 - 240 VAC, 50/60 Hz, 250 watts max
Dimensions (HWD) 22.5 x 13 x 10” / 57 x 33 x 26 cm
Weight 35 pounds / 16 Kg
(Specifications subject to change without notice)