Behringer EG8180 Musical Instrument User Manual


 
EUROGRAND
Basic operation8
In our example the sounds „GRAND PIANO 1" and „STRINGS"
are layered.
To quit layer mode, press any button in the SOUND +
SELECT section. This will also select one single sound
again.
Changing the sound character4.2
You can change the sound character by using a room and a
modulation effect as well as a brightness equalizer.
Brightness equalizer4.2.1
Use the brightness equalizer to change the sound character and
make it softer or more brilliant.
Change the sound character with the BRIGHTNESS control 1)
as follows:
Move the control to the left (SOFT) for a softer sound =
that is darker in tone.
Move the control to the right (BRIGHT) for a more =
brilliant sound.
Room effects4.2.2
The EUROGRAND provides room effects simulating four re-
verb rooms of different sizes. When you select a sound, the
EUROGRAND also selects an appropriate effect. If required,
however, you can always select any other effect. The following
reverb room simulations are available:
ROOM: Simulates a small room.
HALL 1: Simulates a small concert hall.
HALL 2: Simulates a large concert hall.
STAGE: Simulates a typical stage ambience.
Keep pressing the REVERB button until the effect of your 1)
choice has been selected.
The active effect is shown by an LED lighting up next to the ef-
fect name.
If none of the four LEDs lights up, the room effect is +
disabled.
Keep the REVERB button pressed while adjusting the origi-2)
nal vs. effect signal ratio in the VALUE/SONG section using
the -/NO and +/YES buttons.
+
The display reads:
0 ... 20: Effect intensity
(0 = no effect, 20 = maximum effect)
If you want to restore the default settings, keep the REVERB 3)
button pressed, then press -/NO and +/YES simultane-
ously.
Modulation effects4.2.3
The EUROGRAND provides a modulation effect featuring four dif-
ferent types of effect. When you select a sound, the EUROGRAND
automatically adds an appropriate effect for some of the sounds.
If required, however, you can always select any other effect. The
following modulation effects are available:
CHORUS: Chorus effect. „Widens" the sound.
FLANGER: Time-shifted layering of sounds. Produces a
"floating" sound.
TREMOLO: Rapid, constantly repeated changes in the
volume of the sound.
DELAY: Echo effect. Produces time-shifted repetitions of
the sound that decay over time.
Keep pressing the EFFECT button until the effect of your 1)
choice has been selected.
The selected effect is shown by an LED lighting up next to the
effect name.
If none of the four LEDs lights up, the modulation effect +
is disabled.
Keep the EFFECT button pressed while adjusting the original 2)
vs. effect signal ratio in the VALUE/SONG section using the
-/NO and +/YES buttons.
+
The display reads:
0 ... 20: Effect intensity
(0 = no effect, 20 = maximum effect)
If you want to restore the default settings, keep the EFFECT 3)
button pressed, then press -/NO and +/YES simultane-
ously.