Filter
Top Products
PAGE 37
FIREBALL INSTALLATION & USER’S GUIDE - M22001-01A1
CHAPTER 2 - SETTING UP FIREBALL
Connecting Pioneer Changers
u Use an RS-232 cable (not supplied with FireBall) with connectors made
specically so that one end connector ts the pin conguration for FireBall and
the other end connector ts the pin conguration for your specic CD changer.
Refer to Appendix A for the pin congurations.
v Insert one end of the cable (the FireBall connector end) into an RS-232 COM
port on FireBall. There are 3 available COM ports.
w Insert the other end of the cable (the connector that ts the CD Changer) into the
RS-232 port on the CD Changer.
x To connect additional CD changers, repeat steps 1 through 3 using the other
COM ports.
y Connect audio from each CD Changer to FireBall. Connections using optical
cables to the digital ports will produce the highest quality audio.
z Make sure the changer is powered on.
2
Refer to Appendix A for cable pin-
out congurations.
2
When connecting digital audio
inputs to FireBall, make sure
Digital Audio 1 is from Changer
1, Digital Audio 2 is from
Changer 2, and Digital Audio 3 is
from Changer 3.