Filter
Top Products
PAGE 206
FIREBALL INSTALLATION & USER’S GUIDE - M22001-01A1
APPENDIX H - REMOTE CONTROL
If the LED did not blink twice, then repeat steps 2 through 3 and try entering the
same code again.
4. Aim the Remote at the component and press PWR once. It should turn off. If it does
not respond, repeat steps 2-3, trying each code for your brand until you nd one that
works. If the device does not have a PWR key, press PLAY.
5. Repeat steps 1 through 4 for each component you want the Remote to control.
Programming TV/VCR Combo
1. Turn on the TV/VCR Combo and insert a video cassette. NOTE: Please read steps
2-4 completely before proceeding. We recommend highlighting or writing down the
code for the brand you wish to program before moving onto step 2.
2. On the Remote, press DVD. Press and hold CODE SET until the LED blinks twice,
then release CODE SET.
3. Use the Setup Codes For TV/VCR Combos (last section in this appendix) to locate
the brand name and then enter the rst four-digit code for your component. If
performed correctly, the LED will blink twice. NOTE: If the LED did not blink
twice, then repeat steps 2 through 3 and try entering the same code again.
4. Aim the Remote at the component and press PWR once. It should turn off. If it does
not respond, repeat steps 2-3, trying each code for your brand until you nd one that
works. If it still does not work, try searching for the code (see Searching For Your
Code). NOTE: If the device does not have a PWR key, press PLAY.
5. If you’ve located a setup code that works, but it has a separate TV code, you’ll also
need to program it into the Remote to access volume control as follows: