Filter
Top Products
PAGE 36
FIREBALL INSTALLATION & USER’S GUIDE - M22001-01A1
CHAPTER 2 - SETTING UP FIREBALL
u Set CD Control on all Sony Changers to 1. This is either a switch setting on
the back of the changer or a front panel menu selection. Please refer to your
Sony manual for instructions.
v Connect audio from each CD Changer to FireBall. Connections using optical
cables to the digital ports will produce the highest quality audio. Escient
recommends also connecting the analog audio outputs to FireBall in the event
you wish to record SCMS encoded disks. If both analog and digital audio
connections are enabled, FireBall will automatically select the best playback/
record mode for each disc.
w Sony 300 and 400 disc changers should be set to “CONTROL A1 II” mode.
Please consult your changer's user manual for instructions on how to set this
mode.
Note: If the menu display on the Sony changer reads “CONTROL A1?” press
NO to set it into the proper mode. If the menu display reads “CONTROL A1
II?” press YES to set it into the proper mode.
2
When installing digital audio in-
puts and S-Link input to FireBall,
make sure S-Link 1 and Digital
Audio 1 are from Changer 1,
S-Link 2 and Digital Audio 2 are
from Changer 2, etc.
2
Analog audio from multiple Sony
changers can be daisy chained
from most Sony Changers to the
single FireBall analog audio input.