Filter
Top Products
Selecting Live Mode and Pushing or Pulling a Configuration
To switch from emulate mode to live mode:
1. Click the Mode Live button (see item
a
below). The Connect to device dialog box
opens.
or
MVC 121 Plus
1
4a
4b
3a
3b
3c
2
2
Figure 25. Selecting Live Mode
2. If necessary and as desired, click either the:
• RS-232 tab (for connection to the rear panel RS-232 ports — proceed to step 3).
• USB tab (for connection via the front panel configuration port — proceed to
step 4).
3. If RS-232 was selected in step 2:
a. Click the com port drop-down menu and select the PC comm port connected to
the rear panel RS-232 port.
b. Check the baud rate displayed in the comm port selection window. If the baud
rate does not match the device rate, click the Baud Rate drop-down menu and
select the desired baud rate. The default is 38400.
c. Click OK.
The Synchronize with Device dialog box (figure 26) appears. Proceed to step 5.
4. If USB was selected in step 2:
a. Click the USB Device drop-down menu and select MVC 121 (or Extron USB
device
, if MVC 121 is not available),
b. Click OK.
The Synchronize with Device dialog box (figure 26) appears. Proceed to step 5.
5. Click either the:
a. Pull radio button to configure the DSP Configurator program to match
the device — proceed to step 6
-or-
b. Push radio button to configure the device to match the DSP Configurator
program — proceed to step 6
MVC 121 Plus • Software Control 46