DesignJet 2800CP
HP Parts Reference Guide™
www.h
.com/
o/h
arts
Carriage Drive Parts
Belt
1
C4704-60207 Carriage (Y-axis) belt - Drives the carriage assembly
Bracket
2
C4704-00005 Y-axis motor bracket - Includes edge wire saddle - Holds Y-Axis Motor
Bushing
3
C4704-40084 Rear slider rod bushing (Spring loaded)
Cable
4
C4704-60015 Carriage board trailing cable with ferrite - Three ribbon cables bundled together - 1.9m (6.3ft) long
Carriage Kit
5
C4723-69096 Carriage assembly - Includes carriage assembly, line sensor, encoder, rear bushing, calibration pen, digitizing sight,
guages - Trailing cable and cable clamp not included
REQUIRES RETURN OF DEFECTIVE PART
C4723-60096 New Part for C4723-69096
Clamp
6
C4704-40085 Trailing cable clamp - Secures the trailing cable to the carriage assembly
Cover
7
C4704-40080 Encoder strip roof
8
C4704-60117 Line sensor lens cover
Ferrite Assembly
9
9170-1687 Ferrite core - Installed on Y-AXIS motor cable
Ground Strap
10
C4704-00016 Encoder ground strap - Provides ground to end of encoder strip
11
C4704-00035 Ground strap - Attached to Y-AXIS bracket
Motor
12
C4723-60277 Carriage (Y-Axis) motor assembly - Drives carriage belt - Includes motor, motor holder, and cable
Pulley
13
C4704-60020 Idler pulley - For carriage (Y-axis) belt - On right end of plotter
Saddle
14
0460-2536 Edge wire saddle for Y-axis bracket
Sensor
C4723-60096 Line sensor - Detects paper width and skew - Measures calibration accuracy and printhead alignment
Spring
16
C1633-80014 Compression spring - For the rear bushing on the carriage
17
C4699-00016 Encoder spring
Strip
18
C4704-60224 Encoder strip - Used to determine carriage position
Tensioner
19
C4723-60063 Y-axis tensioner assembly - Applies tension to carriage belt - Includes wedge, tensioner spring, and housing
Electronic Accessories
Cable (Interface)
5063-1256 IEEE-1284 Bi-Tronics parallel cable - DB-25 (M) connector (type A) to 36 pin Centronics (M) connector (type B) - 2.0m
(6.6ft) long
5063-1257 IEEE-1284 Bi-Tronics parallel cable - DB-25 (M) connector (type A) to 36 pin Centronics (M) connector (type B) - 3.0m
(9.8ft) long
92215S RS-422 serial cable - 8 pin (M) to 8 pin (M) - 2.0m (6.6ft) long - For connecting Apple Macintosh with LocalTalk/serial
connector
