Filter
Top Products
19
English
Ⅵ Switch setting
● Set the [CARBON/DYNAMIC] switch according to
the type of intercom headset microphone to be
used. (If JVC Headset KA-310U is connected,
choose the [CARBON] setting.))
● Set the [INCOM MIC ON / OFF] switch depending
on whether headset microphone will be used. If the
switch is set to [ON], then the headset microphone
could be used.
[CARBON/DYNAMIC]
switch
[INCOM MIC ON/OFF] switch
Rear view of
this unit
Operation
GENLOCK IN
VIDEO OUT
DC IN
POWER
SEE INST
INTERCOM
INCOM MIC
INCOM LEVEL
ON
OFF
MAXMIN
DYNAMIC
CARBON
PUSH
CALL
VF
[CALL]
Indicator
[CALL] button
[INCOM LEVEL]
volume
GENLOCK IN
VIDEO OUT
DC IN
POWER
SEE INST
INTERCOM
INCOM MIC
INCOM LEVEL
ON
OFF
MAXMIN
DYNAMIC
CARBON
PUSH
CALL
VF
● When this unit’s [CALL] button is pressed and held
down, call signals will be sent to the remote control
unit operator and the [TALLY] button indicator of
the remote control unit will blink.
During this duration, the [CALL] indicator of this unit
will light up. The Viewfinder’s [TALLY] lamp will also
blink when call signals are received from the re-
mote control unit.
● The headset reception volume could be adjusted
by [INCOM LEVEL] volume.
Note
After the power is turned on, the camera remote control unit takes about 30 seconds to
be ready to communicate with this unit.
Connecting to Remote Control Unit RM-P210 (continued)
● Turn the [POWER] switch of the camera remote control unit to [ON]. After the [POWER]
switch is turned on, camera remote control unit could be operated after about 30 seconds.
Note
● If both this unit (including the camera) and the remote control unit have the same func-
tional switches, the remote control unit switches will be accorded higher priority.
● If local Remote Control Unit (RM-LP55 or RM-LP57) is used simultaneously, the local
remote control unit will be accorded higher priority.
● When synchronization signal is added to both the camera and the camera remote con-
trol unit, pictures will be distorted. (☞ page 9 ‘Regarding Gain-lock Signal and adjust-
ment of System Phase’)
● If external synchronization signal is present when the power is turned on, pictures may
appear jerky for a few seconds. This is not a malfunction.
● When using the remote control unit, refer to its instruction manual for details.