Filter
Top Products
9
English
Precautions
ⅷ In order to ensure that this unit could serve
you longer, avoid storing or using it at the
following places.
Ⅵ Extremely hot or cold places
Ⅵ Places with strong vibration
Ⅵ Dusty places
Ⅵ High humidity places
Ⅵ In the vicinity of strong noise sources
ⅷ Do not subject this unit to strong vibration
or impact when installing or moving it.
ⅷ Do not plug in or plug out the camera ca-
ble connector when this unit has been pow-
ered on.
ⅷ Use only the designated power supply. Use
either RM-P210 or AA-P250.
ⅷ To reduce power consumption, turn off the
power when not in-use.
ⅷ When transceiver or mobile phone is used
near this unit, noises may be introduced
into the intercom speaker or the screen.
This is not a malfunction.
Moving this unit with the supporting tripod
attached may cause it to detach and drop
if there is sudden external impact or
vibration. This may cause injuries. Please
remove this unit from the tripod before
moving it.
Caution
ⅷ Earthing the INTERCOM G(GND) terminal
is recommended as noises may be induced
depending on the intercom headset used.
ⅷ Use only the specified standard length
camera cable. Otherwise, the cable com-
pensation may be insufficient.
Regarding Gain-lock Signal and adjustment of System Phase
When using RM-P210 Remote Control Unit
with this system, Gain-lock signal could be
input into either KY-F560 Camera or RM-
P210.
However, if Gain-lock signal is applied to both
KY-F560 and RM-P210, screen images will
appear jerky.
Please carry out the System Phase
adjustment via the machine where Gain-lock
signal has been input.
In addition, the first priority will be given to
RM-LP55 when connecting it.
Ⅵ When Gain-lock signal is input into RM-
P210
Please adjust the phase by adjusting RM-
P210’s H and SC.
Use RM-LP55 to adjust the phase if it is
connected to this system.
Ⅵ When Gain-lock signal is input into KY-
F560
Please adjust the phase by adjusting KY-
F560’s H and SC.
(Adjustment should be done through KY-F560
even if RM-P210 is connected).
Use RM-LP55 to adjust the phase if it is
connected to this system.