Filter
Top Products
35
Step 6. Changing the time location
This section explains how you can move the counter
that shows the current location within the song.
1. Switching the counter display
You can switch the units of the current time shown by
the counter.
1 Select the “ ” button located at the left of the
counter, and press the [ENTER] key to access the
“Select TimeDisp Type” dialog box.
2 Select the location units that you wish to view,
select the “OK” button and press the [ENTER]
key.
You can select one of the following four types of
display.
In order for the “__.__ Free” display to accurately
indicate the remaining time, you must set the
recording track [TRACK STATUS] to REC, and set
the counter display to “FreeTime.” When you do
so, the remaining recording time will be displayed
according to the number of tracks that are set to
REC.
2. Moving the current time location
Using the counter to move
1 Select a page in which the counter is displayed in
the upper part of the LCD screen, such as the
[SONG] “SelSong” tab page.
2 Select the portion in the counter that you wish to
change to a new location.
3 Rotate the [VALUE] dial to move the time.
Using the [FF] or [REW] keys to move
Moving backward
Press the [REW] key to move toward the beginning
of the song. If you hold down the key, you will
move continuously.
You can also move during playback.
Moving forward
Press the [FF] key to move toward the end of the
song. If you hold down the key, you will move con-
tinuously.
You can also move during playback.
Moving to the beginning of the song
When the current time is in the middle of the song,
hold down the [STOP] key and press the [REW]
key to move to the beginning of the song.
Moving to the end of the song
When the current time is in the middle of the song,
hold down the [STOP] key and press the [FF] key
to move to the end of the song.
Using the locate keys to move
(LOC1, LOC2, LOC3, LOC4)
You can register specific times in the locate keys, and
jump instantly to those times.
Up to four locate points can be registered for each song.
Use the [IN/LOC1], [OUT/LOC2], [TO/LOC3], and
[END/LOC4] keys.
In addition to recalling the locate times that you
register, these keys are also used to specify the time
locations for auto punch recording (IN/OUT
times) and for track editing (the editing region).
For details on the various locate functions, refer to
p.97.
Registering a locate point
1 Move the current time to the location that you
wish to register.
Use the counter (“Counter”) or the [FF]/[REW]
keys to change the current time.
2 Press the [STORE] key to capture the selected
time location.
3 Register the time location you captured.
Press one of the [IN/LOC1], [OUT/LOC2], [TO/
LOC3], or [END/LOC4] keys to register the saved
location in that key. The registration will be com-
pleted as soon as you press the key.
Even if you perform steps 2 and following
during playback or recording, the time loca-
tion at the moment you pressed the [STORE]
key will be preserved, and can be registered in
a locate point.
• ___.__.___ “measures” . “beats” . “1/96 of a beat”
• ___:__.___ “minutes” : “seconds” . “1/1000 of a second”
• ___:__.__F “minutes” : “seconds” . “1/30 of a second”
• ___.__ Free “minutes” . “seconds” (remaining available
recording time)
Basic operation
Changing the
time location