Filter
Top Products
80
Initialize: The drive selected by “Drive ID” will be
initialized.
Format: The drive selected by “Drive ID” will be
formatted.
Force .........................................................[On, Off]
This setting allows a disk to be formatted or initial-
ized even if it contains a protected song.
On: Even if the disk contains a song protected by
“Protect Song,” initialization will be performed
forcibly.
Off: If the disk contains a song protected by “Pro-
tect Song,” a message of “Song Protect” will be dis-
played when you attempt to initialize, and the
command will be aborted.
LoadSystem: System software will be loaded from
the drive selected by “Drive ID” to rewrite the oper-
ating system of the D12. For details refer to “Updat-
ing the system software” (→p.135).
P1 RecMode: Selecting the
recording mode
1. Select RecMode................................. [Input, Bounce]
Select the recording mode.
Input: The input (analog, digital, internal rhythm,
internal CD) will be recorded. The recording level of
each track is adjusted by the channel faders. Select
this for normal recording.
Bounce: The master LR bus will be recorded. The
playback level of each track is adjusted by the chan-
nel faders, and the recording level is adjusted by the
master faders.
You will select this mainly for the following situa-
tions.
• Pingpong recording (combining multiple tracks
to two tracks)
• Recording the sound processed by the master
effect
• Recording multiple inputs on two tracks.
When “Bounce” is selected, a maximum of two
tracks can be recorded simultaneously.
P2 Bounce: Settings for bounce
recording
For the procedure of bounce recording, refer to p.29.
1. Select BounceMode...........[10Tr+2In→2Tr, 12Tr→2Tr]
Select the type of bounce recording.
10Tr+2In→2Tr: Select this when recording 10 tracks
of playback + 2 inputs onto two tracks.
The input sound selected in the [INPUT] “Ch1–6”
tab page and “Ch7–12” tab page will be valid for the
channel(s) whose [TRACK STATUS] key is set to
REC (LED lit red), and will be recorded together
with the other playback tracks.
12Tr→2Tr: Select this when recording 12 tracks of
playback onto two tracks.
The track playback will be valid for the channel(s)
whose [TRACK STATUS] key is set to REC (LED lit
red), and will be recorded together with the other
playback tracks.
Be aware that if “Rhythm” is set to “On” during
bounce recording, the rhythm will also be recorded
together with the other sounds (→p.61).
2. RecordVirtualTrack ............................[Current, a…h]
Select the recording destination virtual track.
Select the virtual track of the recording track
selected by the [TRACK STATUS] key on which
bounce recording will occur.
By selecting a virtual track “a”–”h” other than
“Current,” you can combine tracks 1–12 into two
tracks without erasing any of the tracks 1–12.
Current: The currently selected track
a…h: The specified virtual track
However if the same virtual track is selected both
here and for [TRACK] “Vtr1–6” or “Vtr7–12” tab
page the result will be the same as if “Current” were
selected.
To avoid accidentally recording a track that has
already been recorded, use the [TRACK] “Vtr1–
6” and “Vtr7–12” tab pages to see which virtual
tracks are currently selected and which contain
data.
3. RECORD
1
1
2