Filter
Top Products
95
4. SelRhythm.............................. [(Rhythm Pattern List)]
Specify the rhythm parameter that will be used
when “TempoSource” is set to “Manual.” In the
cases of “TempoMap” and “TempoTrack,” this will
show the rhythm(→P1-2) corresponding to the cur-
rent time as specified in the “TmpMap” tab page.
Press the “ ” button, and select a pattern from a
dialog box.
The rhythms that can be selected will depend on the
“Beat
.” (→p.142)
5. RhythmVol............................................. [000…100]
Specify the volume of the rhythm.
When the [SOLO/MONITOR] “Monitor” tab page
“Rhythm” button is turned OFF, this volume is sent
to the master LR bus. When the button is turned
ON, it is sent to the monitor LR bus.
6. Rhythm ..................................................... [On, Off]
Turn the rhythm on/off.
You can specify whether or not the rhythm will play
during recording and playback.
On: The rhythm will sound. The
[TEMPO/RHYTHM] key LED will light.
Off: The rhythm will not sound.
Be aware that during bounce recording, the rhythm
will be recorded if this setting is “On.”
The rhythm that is input for [INPUT] “Ch1–6” and
“Ch7–12” tab page (“RhythmL” and “RhythmR”)
will sound during recording or playback whether
this setting is On or Off.
If the [SETUP] “TmpMap” tab page “Rhythm”
parameter is “On,” the rhythm will sound as long
as this page is displayed, even if the recorder is
stopped. At this time, the rhythm will continue
sounding even if you select the “METER/TRACK
VIEW” page.
7. Pattern Length, Pattern Position ................................
This shows the length (number of measures) of the
rhythm pattern selected by “SelRhythm,” and the
measure that is currently playing.
Example: (L4:1)... currently playing measure 1 of a
four-measure pattern
P2 TmpMap: Editing the tempo
map
By creating a tempo map, you can cause the tempo,
time signature, and rhythm pattern to change while the
song is recorded or played back.
For details on creating a tempo map, refer to p.62.
Changes in tempo, time signature, or rhythm can be
made only at the beginning of a measure.
1. TempoMap............................................. [001…200]
This is the number of the selected tempo map.
The starting measure, ending measure, tempo, time
signature, and rhythm pattern of this tempo map
are shown at the right.
Press the “ ” button and select a tempo map from a
dialog box.
When “TempoSource” (→P1-1) is “Manual,” it is
not possible to select “TempoMap.”
2. New.......................................................................
Create a new tempo map.
When you wish to add a tempo map in the middle
of the song, create a new tempo map.
The following “Select TempoMap*** Param” dialog
box will appear.
2a. StartMeas........................................ [001...999]
Specify the starting location of the tempo map that
will be created.
This is specified in units of a measure.
2b. EndMeas ......................................... [001...999]
Specify the ending location of the tempo map that
will be created.
This is specified in units of a measure.
2c. Tempo ................................................[40…240]
Specify the tempo. The units are =40–240.
2d. Beat ........................................ [01/04…16/16]
Specify the time signature.
2e. Rhythm ............................. [(Rhythm Pattern List)]
Specify the rhythm. If you wish to specify a period
of silence, you can select a silent rhythm.
Press the “ ” button and select a rhythm from a
dialog box.
The rhythms that can be selected will depend on the
“Beat
” setting. (→p.142)
1
5
2
4
3
2a
2c
2e
2d 2f2b
Refer
e
TEMPO