Filter
Top Products
106
External disk drive
The external disk drive is not recognized in the [SYS-
TEM] “DiskUtil” tab page
■ Is the external disk connected correctly? (→p.48)
■ Are two or more disk drives set to the same SCSI device
ID?
→ For details on setting the SCSI device ID, refer to the
owner’s manual of your drive.
Disk drive is not recognized when selecting songs
■ Has the disk been initialized?
→ Before recording or copying a song to an external disk
drive (on a HDD or removable disk), the disk must be
initialized. Initialization is not necessary in order to
backup (on a removable disk). If the disk is recognized
in the [SYSTEM] “DiskUtil” tab page, it can be used.
Can’t remove the external removable disk
■ Is a song on the external removable disk currently
selected?
→ If the currently selected song is on the removable disk,
removing the disk may damage the song data; for this
reason, the D16 locks the disk drive. Refer to “Exchang-
ing removable disks” (→p.49), and remove the disk.
After a drive was left for an extended period (ten
minutes or more) after playback or locate, playback
is incorrect
■ Has the drive entered sleep mode?
→ Some drives may enter sleep mode if they have not
been accessed for an extended period of time. Press the
[STOP] key to cancel sleep mode.
CD-R/RW
CD-R/RW drive is not recognized
■ Has the SCSI ID been set to other than 6? (→p.48)
■ Did you turn on the power of the CD-R/RW drive
before turning on the power of the D16?
→ Turn off the power of both the CD-R/RW drive and the
D16, and then turn the power on again in the order of
CD-R/RW drive → D16.
Can’t write
■ Further writing is not possible on a CD-R/RW disc that
has been finalized. (→p.62)
■ It is not possible to write to a CD-RW disc that contains
data created on another device.
Can’t playback the disc on an audio CD player
■ Did you execute the Finalize operation?
→ In the [SONG] “CDR/RW” tab page, press the “Final”
button to execute the Finalize operation. (→p.63)
Confirmation messages
Completed
■ The operation has been completed successfully. Please
press the “OK” button.
SongFull
■ The maximum number of songs that can be stored on a
disk drive has been exceeded.
→ Either delete unneeded songs, or select another drive.
Now ***ing (*** is Copy or Write, etc.)
■ An operation is in progress. Please wait until this dis-
play disappears.
Error messages
Disk
■ Failure while reading from the disk drive.
→ In [SYSTEM] “DiskUtil,” execute “CheckDrive.” If this
message still appears, please delete that song. If this
message still appears even after you have deleted the
song, please re-format the disk drive.
Approximately 40 minutes are required in order to
complete the internal drive “CheckDrive” or “For-
mat” operations.
DiskBusy
■ If this message appears when you have just begun to
use a disk drive, the disk drive is too slow to perform
recording/playback.
→ Please use this disk for backup.
■ Disk drive reading speed may be slowed down if
punch-in/out recording or track editing has caused the
data to be fragmented across the disk.
→ In [TRACK] “EditTrk,” execute “OptimizeTrk.”
DiskRepaired1
DiskRepaired2
DiskRepaired3
■ An error occurred in “Check Drive”
→ Disk Repaired 1 indicated that an error was found but
was repaired. If this message appears, you can continue
using the disk.
Disk Repaired 2 and 3 indicate that the error could not
be repaired completely. If this message appears, it is
possible that the song data has been damaged or lost.
In this case, the song or other data will be erased, but by
initializing the disk you can continue using it as before.
DriveFull
■ The drive capacity is insufficient.
→ Try turning the power off and then on again. (When
recording or editing track data, the current data will be
saved to disk.)
If this message still appears, delete unwanted songs or
select another drive.
Messages