Filter
Top Products
17
• Press the “ ” button to select “PreFaderLev,”
and press the “OK” button.
The ch.1 level meter will move to show changes in
the input.
7 Audition the audio signal.
• Select the [SOLO/MONITOR] “Monitor” tab
page.
• Press the “MasterLR” button to turn it “On”
(highlighted).
• Gradually raise the [PHONES LEVEL] knob or
the [MONITOR OUT LEVEL] knob, and listen
to the audio signal in your headphones or moni-
tor system.
Assign the built-in mic from [INPUT 2] to
mixer channel 2
1 Turn on the built-in mic.
Lower the [MASTER] fader of the D16, and set the
[MIC] switch to INPUT 2 (refer to the diagram on
the previous page).
The [MIC] on indicator will light.
2 Adjust the trim.
Speak or sing near the mic, and adjust the INPUT 2
[TRIM] knob. Adjust the level as high as possible
without allowing the LED to light red.
3 Specify the input channel.
• Select the [INPUT] “Ch1–8” tab page.
• Press the “Ch2” icon, and rotate the [VALUE]
dial to select “Input 2.”
This assigns the input from the built-in mic to
channel 2.
4 Specify the recording track.
Press the track 2 [TRACK STATUS] key to select
REC (the LED will light red).
5 Check the record mode and input level, and audi-
tion the sound.
Refer to steps 5, 6, and 7 of “Assign the guitar
input from [GUITAR IN] to mixer channel 1.”
Assign the keyboard connected to [INPUT
3] and [INPUT 4] to mixer channels 9 and
10
1 Connect your keyboard.
Lower the [MASTER] fader of the D16, and con-
nect your keyboard to the [INPUT 3] and [INPUT
4] jacks (refer to the diagram on the previous
page).
2 Adjust the trim.
While playing your keyboard, adjust the INPUT 3
and 4 [TRIM] knobs. Adjust the level as high as
possible without allowing the LED to light red.
3 Specify the input channels.
• Select the [INPUT] “Ch9–16” tab page.
• Press the “Ch9” icon, and rotate the [VALUE]
dial to select “Input 3.” In the same way, assign
“Ch10” to “Input 4.”
This assigns the input from the keyboard to chan-
nels 9 and 10.
4 Specify the recording tracks.
Press the track 9/10 [TRACK STATUS] key to
select REC (the LED will light red).
5 Check the record mode and input level, and audi-
tion the sound.
Refer to steps 5, 6, and 7 of “Assign the guitar
input from [GUITAR IN] to mixer channel 1.”
Basic operation
Recording