Filter
Top Products
26
High EQ, Low EG
• For the channel that you wish to adjust, select
“High EQ Gain (H)” or “Low EQ Gain (L),” and
rotate the [VALUE] dial to set the amount of
gain. The value is displayed in the upper left of
the screen.
Mid EQ
• For the channel that you wish to adjust, select
“Mid EQ Cutoff Frequency (F),” and rotate the
[VALUE] dial to set the cutoff frequency. The
value is displayed in the upper left of the screen.
• For the channel that you wish to adjust, select
“Mid EQ Gain,” and rotate the [VALUE] dial to
set the gain. The value is displayed in the upper
left of the screen.
Applying input EQ to the analog
inputs/Recording with input EQ
You can apply input EQ to the analog inputs (EQ can-
not be applied to the digital input), and record the
sound that has been adjusted by the EQ.
1 Select the page containing the channel to which
you wish to apply EQ.
Select the [INPUT] “InEq1–4” or “InEq5–8” tab
page.
2 Input an audio source, and adjust its level appro-
priately.
Refer to “1. Selecting the input/record track” and
“2. Adjusting the record level, and recording”
(→p.16, 18).
Verify that the level meter in the left edge of the
LCD screen moves, and that you hear the sound.
3 For each “InputEQ,” select the gain settings and
mid EQ cutoff frequency, and rotate the [VALUE]
dial to adjust them. (→p.25 2 3)
4 Record the sound as adjusted by the EQ.
Refer to “2. Adjusting the record level, and record-
ing” (→p.18).
Adjacent odd and even-numbered channels (1–2, 3–4,
5–6, 7–8) can be paired, so that changing a value for the
odd-numbered channel will simultaneously change the
value for both channels. It is convenient to use mixer
pairing for stereo-recorded channels.
Pairing is valid for the following settings.
• [TRACK STATUS] keys
• EQ (channel EQ)
• EffSnd 1 + 2 (effect send)
• AuxSend (auxiliary send)
• [PAN] knobs
• [CHANNEL] faders
With the exception of the [TRACK STATUS] keys
and the [CHANNEL] faders, you can select
whether or not pairing will be enabled for a
parameter. This selection is made simultaneously
for both Effect Sends 1 and 2.
1 Access the “Select Pair” screen.
Press the “ ” button that is found in the [INPUT],
[EQ/PHASE], and [INSERT EFFECT] pages to
access the following screen.
2 Select “Select PairOn Channel.”
Press the “1 2” – “7 8” buttons to turn “On” pairing
for the desired channels. (When highlighted, the
symbol appears as .)
3 Select the function(s) for which pairing will be
enabled.
Select the function(s) for which pairing will
enabled for the channels selected in “Select PairOn
Channel.”
For “Eq,” “Send,” “Aux,” and “Pan,” press the
functions that you wish to enable. Then press the
“OK” button to execute the settings.
Pairing