Filter
Top Products
32
One stereo-in stereo-out effect is provided as the final
effect. It applies to the master LR output.
How the final effect can be used
The final effect is used mainly for dynamics processing
(compression etc.) to make the overall level more con-
sistent.
During mixdown, you can use the final effect to apply
mastering effects such as a multi-band limiter, in order
to polish the mix for CD-quality results.
Using the final effect
1 Select the [MASTER EFFECT/AUX] “FinalEff”
tab page.
2 Select an effect program.
Press “Ef
fectNumber,” and rotate the [VALUE] dial
to select an effect program.
Play back, and listen to the output from master LR
to hear the result of the effect.
You can edit (modify) the effect programs that are used
as insert effects, master effects, and final effects.
If you select a different “Ef
fectNumber” or turn off
the power without saving, the effect settings you
edited will be lost. If you wish to keep your edited
settings, you must save them after you are finished
editing.
1 Access the page for the effect that you wish to
edit.
The screen shot given here shows an example
where the [INSERT EFFECT] “InsEff1” tab page is
selected.
2 Select an effect program.
Press “Ef
fectNumber,” and rotate the [VALUE] dial
to select an effect program.
3 Listen to the sound produced by the effect pro-
gram.
If you press the “Bypass” button, the effect will be
bypassed (there will be no effect). If you then press
the “Cancel” button, bypass will be switched off
(the effect will be heard). You can use this function
to compare the processed and unprocessed
sounds.
4 View the effects and chain that make up the
selected effect program.
Press the “(EffectProgramName)” button, to view
the “EffectAlgorithm” dialog box for the selected
effect program.
5 As necessary, turn the individual effects on/off.
By pressing the “(Effect On/Off)” button located
below each “(EffectIcon)” button, you can switch
each effect on (highlighted) or off.
6 Adjust the settings of each effect.
• Press the “(EffectIcon)” button for the effect that
you wish to adjust. The following figure shows
the dialog box when “S.Dly” is selected.
• Select a parameter, and rotate the [VALUE] dial
to adjust it. For details on each parameter, refer
to p.89–102.
Final effect Editing an effect