Filter
Top Products
77
P4 InEq5–8: EQ settings for inputs
5–8
Here you can apply EQ (equalizer) to the analog inputs
from the [INPUT 5]–[INPUT 8] jacks. Refer to “P3
InEq1–4: EQ settings for inputs 1–4.”
P5 Tuner: Tuner
You can use the built-in tuner to tune an instrument
connected to the [INPUT 1/GUITAR IN] jack or input
from the built-in mic. You can also measure the pitch of
a track.
Recording is not possible while this page is dis-
played. Nor is it possible to select this page during
recording or playback.
To allow tuning to be performed accurately, the
effects will be turned off while this page is dis-
played.
1. CENT Scale ....................................(–50…+50)
The “▼” symbol in the center will change to “▼”
when the tuning is correct. The amount of pitch
deviation is shown in units of cents (100 cents = 1
semitone, and 1200 cents = 1 octave)
2. NoteDisplay...........................................(C…B)
This shows the name of the note that is closest to
the input sound.
It is not possible to detect the pitch if two or more
notes are played simultaneously.
3. Calib ............................... [435…440…445Hz]
Specify the frequency that will be the basis for tun-
ing. Normally you will set this to “440.”
4. SelectSource................[Input1, Track No1…16]
Input1: Select this when you wish to tune an exter-
nal device such as a guitar, or when using the built-
in mic to tune.
Track No “1…16”: Select the track whose pitch you
wish to measure. Move to the time location that you
wish to measure, then specify the track in this page,
and play back to measure the pitch of the specified
track.
Using the tuner
1 Use “SelectSource” to select the source that you
wish to tune.
• To tune an instrument such as guitar, connect the
instrument to [INPUT 1/GUITAR IN]. To tune
using the built-in mic, set the [MIC] switch
(→p.5) to INPUT1.
Then select “Input 1” for “Ch1” of [INPUT]
“Ch1–8,” and select “Input 1” for “SelectSource”
of [INPUT] “Tuner.”
• To measure the tuning of a track, use “Select-
Source” to select the “Track,” and select the
desired track.
2 Use “Calib
” to set the basic frequency for tuning.
3 Tune your instrument/measure the pitch of the
track.
“Note Display” will indicate the note name, and
“Cent Scale” will indicate the pitch.
• If “Input 1” is selected, play your instrument to
produce sound, and adjust its tuning so that the
solid triangle symbol “▼” appears in the middle.
• If “Track” is selected, move to the time that you
wish to measure, and press the [PLAY] key to
play back. Check the note name and pitch.
3
1
4
2
Reference
INPUT