Filter
Top Products
POWER switch
To apply power to the unit, connect the line cord and flip the switch to the ON position. Three of the four
front panel LED’s should illuminate, indicating power is being supplied. It’s best that the STANDBY switch
(#13) is set to STANDBY when amp is first switched on.
The correct start up sequence is:-
*Before use, both switches should be in the ‘down’ position.
*Switch POWER to ON. Now wait at least 1 minute for the amplifier to warm up.
*Then switch the STANDBY to ON. Use amp as normal.
*Switch to STANDBY for short breaks. (Between sets, not between songs!)
*When through playing, switch to STANDBY, wait at least a few seconds, then switch POWER to
OFF.
14
6505 MH
®
Front Panel cont.