Filter
Top Products
C1997M (3/01)
RMQ10T
Rack Mount Kit
®
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
1. Installation and servicing should only be done by qualified service personnel and conform
to all local codes.
2. Only use replacement parts recommended by Pelco.
3. Use only installation methods and materials capable of supporting four times the maximum
specified load.
Please thoroughly familiarize yourself with the information in this manual prior to installation and
operation.
DESCRIPTION
The RMQ10T Rack Mount Kit is designed to mount a single PMC10A, 10-inch monitor to any
standard 19-inch (48.26 cm) wide console or rack configuration.
The RMQ10T Rack Mount Kit contains the following parts:
Qty Description
2 Monitor mounting brackets
2 Handles
8 Nylon finishing washers (black)
8 Screws,10-32 x .75-inch, Phillips, pan head (black)
4 Screws,10-32 x .50-inch, Phillips, pan head
4 #10 locking washers
4 Screws, 4 x 12-mm, Phillips, pan head (black)
4 #8 locking washers
INSTALLATION
To rack mount the PMC10A monitor, refer to Figure 1 and do the following:
1. Disconnect the monitor from its power supply.
2. Attach the handles to the mounting brackets using the four 10-32 x .50-inch screws and
locking washers.
3. Remove the two screws from the left side of the monitor and the two screws from the
right side.
4. Use the hardware supplied with the rack mount kit and attach the monitor mounting
brackets to the sides of the monitor. Use two 4 x 12-mm screws, locking washers, and flat
washers on each side.
5. Use the eight supplied 10-32 x .75-inch black screws and finishing washers and mount the
monitor assembly to a 19-inch (48.26 cm) rack or console. Installation of the monitor
assembly may require two persons.
6. Reconnect the monitor to its power supply.
3500 Pelco Way
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
International Customers:
Tel +1(559) 292-1981
FAX +1(559) 348-1120
www.pelco.com