Filter
Top Products
19
Before You Play
Connect the pedal cord to the Pedal connector on the rear
panel of F-110.
Plug the pedal cable all the way into the Pedal
connector.
fig.PedalCord.eps_88
To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn
off the power on all devices before making any
connections.
1.
Connect the supplied AC adaptor and power cord.
fig.ACAdpt01.eps_88
Place the AC adaptor so the side with the indicator (see
illustration) faces upwards and the side with textual
information faces downwards.
The indicator will light when you plug the AC adaptor
into an AC outlet.
Depending on your region, the included power cord
may differ from the one shown above.
2.
Connect the AC adaptor to the DC In jack on the
rear panel.
3.
As shown in the diagram, loop the AC adaptor cord
around the cord hook to fasten it in place.
fig.ACAdpt02.eps_88
To prevent the inadvertent disruption of power to your
unit (should the plug be pulled out accidentally), and to
avoid applying undue stress to the AC adaptor jack,
anchor the power cord using the cord hook, as shown in
the illustration.
4.
Plug the Power cord into a power outlet.
If necessary, secure the AC adaptor cord with the cord clamps
Be sure to use only the AC adaptor supplied with the
unit. Also, make sure the line voltage at the installation
matches the input voltage specified on the AC adaptor’s
body. Other AC adaptors may use a different polarity, or
be designed for a different voltage, so their use could
result in damage, malfunction, or electric shock
Depending on the circumstances of a particular setup,
you may experience a discomforting sensation, or
perceive that the surface feels gritty to the touch when
you touch this device, microphones connected to it, or
the metal portions of other objects, such as guitars. This
is due to an infinitesimal electrical charge, which is
absolutely harmless. However, if you are concerned
about this, connect the ground terminal (see figure)
with an external ground. When the unit is grounded, a
slight hum may occur, depending on the particulars of
your installation. If you are unsure of the connection
method, contact the nearest Roland Service Center, or
an authorized Roland distributor, as listed on the
“Information” page.
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be
dangerous in the event of lightning)
Getting Ready to Play
Connecting the Pedal Cord
Connecting the AC Adaptor
AC adaptor
Power cord
Indicator
To an AC outlet
Rear panel
Ground terminal
Cord hook
The cord of
the supplied
AC Adaptor
F-110_r_e.book 19 ページ ２００９年６月３０日 火曜日 午後１２時６分