Filter
Top Products
31
Performing
2.
Press the [–] or [+] button to select the beat.
When you record your performance, it will be recorded
in the beat that is selected.
When you play back a song, the metronome’s beat will
be set to the beat of that song.
You can’t change the metronome’s beat while a song is
playing.
The volume of the metronome can be adjusted, with 11
volume levels available.
This will be set to “5” when you turn on the power.
fig.PlusMinMetro.eps_88
1.
While holding down the [Metronome] button, press
the [-] or [+] button.
The display will indicate the metronome volume.
fig.d-5.eps_88
When the metronome volume is set to “0,” the
metronome sound won’t be heard.
A “count-in” is a count that is sounded before the song
begins to play.
If you’re playing along with a song, you can sound a count to
make it easier to synchronize your own playing with the
song.
1.
Press the [
] button while the metronome is
sounding.
A two-measure count sounds before the song plays.
A “count-down” is a count that is sounded at the end of
the song’s introduction (before you begin playing the
keyboard, see p. 55).
Display
Beat Display Beat
2/2
6/4
Only weak
beats will be
sounded.
7/4
2/4 3/8
3/4 6/8
4/4 9/8
5/4 12/8
Changing the Metronome Volume
Sounding a Count to Keep Your
Timing Accurate
F-110_r_e.book 31 ページ ２００９年６月３０日 火曜日 午後１２時６分