Filter
Top Products
Back Plane Connector
This is the connector to the phone system.
LED Indications
There are Eight (8) LEDs on the SVMi-8E/SVMi-16E motherboard, the one marked HD will flash whenever the hard
disk drive is being accessed, others will give indications of various board functionality.
HD Access LED
The HD access LED will flash whenever the Hard Drive or CF
is being accessed. This works in a similar way to the Hard Disk
access LED on your desk top PC.
VM1 Status LED (SVMi-8E Only)
This indicates that one or more of the 1st four ports (port 1
thru 4) are off hook. If you were to reset or turn the power off
you would disconnect the caller connected to the active
port(s).
VM2 Status LED (SVMi-8E Only)
This indicates that one or more of the Last four ports (port 5
thru 8) are off hook. If you were to reset or turn the power off
you would disconnect the caller connected to the active
port(s).
VM3 Status LED (SVMi-8E Only)
This LED is currently not in use.
AP/D and SD Status LEDs (SVMi-16E Only)
The Status LEDs show the operating status of the card. A status of green indicates SVMi-16E is down and it is safe
to power off the switch. A status of red indicated the SVMi-16E is up and running and it is NOT safe to power down
the switch without possible corruption to the SVM databases.
VPM Connectors
This is a proprietary connector for installing 1 voice processing module (VPM) on the SVMi-8E and up to 2 VPMs
on the SVMi-16E. Any of the VPM connectors can be used for either of the two types of VPMs. The VPMs are, a
VPM-E that provides an additional 4 voice ports and a VPMF-E that also provides an additional 4 ports but enables
one port to be used for Fax applications.
Hardware Description
2.8
SVMi-16E
SVMi-8E