Filter
Top Products
16
Troubleshooting
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help –
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
If you experience Possible Causes Solution
Dryer Results (cont.)
Clothes are not drying
satisfactorily or drying
times are too long
(cont.)
The exhaust vent is not the correct
length.
Check that the exhaust vent is not too long or has too many
turns. Long venting will increase drying times. See the Installation
Instructions.
The exhaust vent diameter is not
the correct size.
Use 4” (102 mm) diameter vent material.
The dryer is not level. Clothes not contacting the moisture sensors during Automatic cycles.
See “Level Dryer” in the Installation Instructions.
The Air Only temperature setting
has been selected.
Select the correct temperature for the types of garments being dried.
See “Cycle Guide.”
The load is too large and heavy
to dry quickly.
Separate the load to tumble freely.
Fabric softener sheets are
blocking the grille.
The air outlet grille is just inside the door, behind the lint screen. Check
that it is not blocked by a fabric softener sheet.
Use only one fabric softener sheet, and use it only once.
The dryer is located in a room with
temperature below 45ºF (7ºC).
Proper operation of dryer cycles requires temperatures above 45ºF
(7ºC).
The dryer is located in a closet. Closet doors must have ventilation openings at the top and bottom of
the door. The front of the dryer requires a minimum of 1” (25 mm) of
airspace, and, for most installations, the rear of the dryer requires 5”
(127 mm). See the Installation Instructions.
Cycle time is too
short
The load may not be contacting
the sensor strips on Automatic
Cycles.
Level the dryer. See the Installation Instructions. All four dryer feet
should be in rm contact with the oor.
Steam models only: Clothes are
coming out of the Steam Refresh
cycle with damp or wet spots.
Under certain environmental or installation conditions, you may
experience underdrying.
The automatic cycle is ending
early.
Change the dryness level setting on Automatic Cycles. Increasing or
decreasing the dryness level will change the amount of drying time in a
cycle. If loads are consistently ending too early, see also “Changing the
Automatic Cycle settings to increase or decrease drying time.”
Lint on load Lint screen is clogged with lint. Clean lint screen before each load.
Stains on load Improper use of fabric softener. Add dryer fabric softener sheets at the beginning of the cycle. Fabric
softener sheets added to a partially dried load can stain your garments.
Do not use fabric softener sheets with steam cycles.
Stains on drum Loose dyes in clothes. Drum stains are caused by dyes in clothing (usually blue jeans). These
will not transfer to other clothing.
Loads are wrinkled The load was not removed from
dryer at the end of the cycle.
Steam models only: Select Steam Refresh Cycle to tumble
the load with water and heat. This cycle is best for smoothing out
wrinkles and reducing odors from dry loads consisting of wrinkle-free
cotton, cotton-polyester blends, common knits, and synthetics.
NOTE: Refer to garment care label instructions. Dry-clean-only
garments are not recommended.
The dryer was tightly packed. Dry smaller loads that can tumble freely. Results may also vary
depending on fabric type.
Steam models only: For steam
cycles, the water is not properly
connected with the dryer.
Steam models only: Make sure water is connected to the dryer.
Check that water inlet hose is connected to both the faucet and dryer’s
water inlet valve. Check that the water supply is turned on.