Filter
Top Products
22 Input Channels
01V96i—Reference Manual
Panning Input Channels
Input Channels can be panned in the range of L63 through
CENTER to R63. To pan each channel, press the
[PAN/ROUTING] button repeatedly until the Pan/Route |
Pan page appears.
Move the cursor to the desired Pan control, then rotate the
Parameter wheel to set the value.
1 Pan controls
These knobs adjust the channel pan settings.
Press the [ENTER] button to reset the currently-selected
Pan control to center.
2 MODE
The MODE parameter determines how paired Input
Channels are panned. There are three Pan modes as fol-
lows:
• INDIVIDUAL
In Individual mode, paired Input Chan-
nel pan controls operate independently.
•GANG
In Gang mode, paired Input Channel
pan controls operate in unison, main-
taining the current pan range.
•INV GANG
In Inverse Gang mode, paired Input
Channel pan controls operate in unison
but move in opposite directions.
Routing Input Channels
You can route each Input Channel to the Stereo Bus, Bus 1–8,
or its own Direct Out. With the default setting, signals are
routed only to the Stereo Bus. However, you can patch signals
to a single or multiple destinations, if necessary.
1. Press the DISPLAY ACCESS [PAN/ROUTING]
button repeatedly until the page listed below
that contains the desired channels appears.
•ROUT1-16 page
This page enables you to change the routing for Input
Channels 1–16.
•ROUT17-ST1 page
This page enables you to change the routing for Input
Channels 17–32 and ST IN Channels 1–4.
The parameters on these two pages (and the procedure for
setting them) are the same.
1 PAN buttons
These buttons determine whether the channel’s Pan set-
ting is applied to the Bus outs. In surround mode, they
also determine whether the Surround Pan setting is
applied to the Bus Outs.
2 Bus buttons 1–8
These buttons route the currently-selected Input Channel
to the Bus Outs. If the 01V96i is in Surround mode, the
button indicators change as follows, depending on the
selected Surround mode:
L=Left, R=Right, C=Center, S=Surround, Ls=Left Sur-
round
Rs=Right Surround, E=Low Frequency Effect, Bs=Back
Surround
The above table shows the default assignment. The actual
assignment may vary, depending on the settings on the
DIO/Setup | Surround Bus Setup page.
Tip:
• You can adjust the pan setting for the ST IN Channels L/R sep-
arately.
• You can also adjust the pan setting for the Input Channels using
the PAN control in the SELECTED CHANNEL section.
• Surround Pan is available when the 01V96i is in Surround
mode. See page 52 for more information on Surround Pan.
2
1
Bus buttons 12345678
Surround mode: 3-1 LRCS5678
Surround mode: 5.1 LRLsRsCE78
Surround mode: 6.1 LRLsRsCBsE8
576
1
3
4
8
2