Yamaha 01V96i Music Mixer User Manual


 
Setting the Input Channels from the Display 23
01V96i—Reference Manual
Input Channels
3 S
When this button is turned on, the currently-selected
Input Channel is routed to the Stereo Bus.
4 D
When this button is turned on, the currently-selected
Input Channel is routed to its Direct Out. See page 46 for
more information on the Direct Out.
5 ALL STEREO
This button turns on the S button for all channels on the
page.
6 ALL BUS
This button turns on the Bus buttons 1–8 for all channels
on the page.
7 ALL CLEAR
This button clears all routing assignments on the page.
8 SURROUND MODE
This field displays the current Surround mode.
Viewing Input Channel Settings
You can view and adjust parameter settings for the cur-
rently-selected Input Channel on the View | Parameter or
Fader pages.
Viewing the Gate, Compressor, and
EQ Settings
To display the View | Parameter page for a specific Input
Channel, use the corresponding [SEL] button to select the
desired channel, then press the DISPLAY ACCESS [VIEW]
button repeatedly.
Move the cursor to a parameter you wish to change, then
rotate the Parameter wheel or press the [INC]/[DEC] buttons
or [ENTER] button to modify the setting.
The following parameters are available (sections marked with
an asterisk (*) are unavailable for the ST IN Channels).
1 GATE section (*)
This section enables you to turn the gate-type dynamics
processor on or off and set the parameters. (See page 19
for more information.)
2 COMP section (*)
This section enables you to turn the compressor-type
dynamics processor on or off and set the parameters. (See
page 20 for more information.)
3 INSERT section (*)
This section enables you to turn the Insert on or off and
patch the Insert In and Out. (See page 47 for more infor-
mation.)
4 EQ section
This section enables you to set various EQ parameters.
(See page 21 for more information.)
5 Meters
These meters indicate the signal levels of the cur-
rently-selected Input Channel and its available pair part-
ner.
6 (Phase) section
You can reverse the signal phase of the currently-selected
Input Channel. (See page 18 for more information.)
Tip: The routings of the ST IN Channels L/R are linked. The D
button is unavailable for the ST IN Channels.
2
1
3 54 6
8
7