Filter
Top Products
26 Input Channels
01V96i—Reference Manual
If the check box is off, the parameter value currently
being adjusted pops up.
See page 21 for more information on EQ.
Pairing Input Channels
On the 01V96i, you can pair adjacent odd-even Input Chan-
nels or counterpart channels on Layer 1 and Layer 2 that share
the same physical fader. Faders and most parameters of paired
channels are linked for stereo operation. Paired channels’
linked parameters and non-linked parameters (that are avail-
able for independent control) are listed below:
* You can set this parameter for each channel indepen-
dently if the GANG button is turned off on the
/INS/DLY | DLY page.
** You can set this parameter for each channel indepen-
dently on the EQ | ATT page, but the paired channel set-
tings are linked on the EQ | Edit and View pages.
To pair channels, or to cancel channel pairs, you can use the
[SEL] buttons on the top panel or access the Pair/Grup pages.
Tip:
• Pressing and holding down the button selected in Step 2 resets
the corresponding band gain.
• Pressing the SELECTED CHANNEL [HIGH] and [LOW]
buttons simultaneously resets the Q, frequency and gain for
each band.
Linked parameters Non-linked parameters
[SEL] buttons Input patches
Faders Insert patches
Channel on/off Output patches
Insert on/off Comp insert position
Solo on/off Phase
Solo Safe Delay on/off
Aux on/off Delay time
*
Aux Send level Delay feedback
Aux Sends as Pre or Post Delay mix
Gate Routing
Comp settings Pan, Follow Pan
EQ settings Surround pan
Fader group Aux Send pan
Mute group Balance
Fade time Attenuators
**
Recall Safe
Note: You cannot pair an ST IN channel 1–4 with an Input Chan-
nel.