Filter
Top Products
Output Patching 45
01V96i—Reference Manual
Input & Output Patching
3. Press [ENTER] to confirm the change.
Patching the USB Outputs
By default, the following output signals are assigned to USB
OUT.
If you want to change or verify this patching, proceed as fol-
lows.
1. Press the DISPLAY ACCESS [PATCH] button
repeatedly until the Patch | USB Out page
appears.
The parameter boxes underneath each number indicate
the currently-assigned signal routing. The meaning of
these indicators are explained below.
2. Move the cursor to a parameter box, and use
the Parameter wheel (or [INC]/[DEC]) to
modify the patching.
3. Press [ENTER] to confirm the change.
Patching the 2TR Digital
Outputs
Follow the steps below to change the signal path patched to
the 2TR OUT DIGITAL connector.
1. Press the DISPLAY ACCESS [PATCH] button
repeatedly until the Patch | 2TR Out page
appears.
Signals assigned on the Out Patch page can also be
assigned on this page.
2. Move the cursor to a patch parameter you
wish to change, then rotate the Parameter
wheel or press the [INC]/[DEC] buttons to
modify the patching.
3. Press [ENTER] to confirm the change.
Tip: You can store the Output Patch settings to the Output Patch
library. Refer to “Libraries” on page 74 for more information.
Outputs Signals
USB OUT1–8 Bus Out 1–8 signals
USB OUT9–16 Bus Out 1–8 signals
Parameter value Description
– No assignment
BUS1–BUS8 Bus Out 1–8 signals
AUX1–AUX8 Aux Out 1–8 signals
ST L/R Stereo Out signals
INS CH1–INS CH32
Input Channels 1–32 Insert
Outs
INS BUS1–INS BUS8 Bus Out 1–8 Insert Outs
INS AUX1–INS AUX8 Aux Out 1–8 Insert Outs
INS ST-L/ST-R Stereo Out Insert Outs