Yamaha 01V96i Music Mixer User Manual


 
Using Fader Group Master 61
01V96i—Reference Manual
Grouping Channels & Linking Parameters
Using Fader Group Master
The
01V96i
features a Fader Group Master function that
enables you to control the level of all channels using the Group
Master level while maintaining the relative balance between
channels, much like a VCA group on an analog mixing console.
While this function is enabled, channel fader operation does
not affect channel levels in the corresponding Fader group.
1. After you perform Step 5 in “Using Fader
Groups and Mute Groups” on page 59, use
the cursor buttons to select the INPUT FADER
MASTER check box or the OUTPUT FADER
MASTER check box, then press [ENTER] to
turn on the Fader Group Master function.
2. When the Fader Master check box is checked,
you can set channel levels of the Fader groups
in the Master column.
When the Master column is selected, repeatedly pressing
the [ENTER] button turns the Fader group on and off.
You can also make these settings in the In Master page or
Out Master page, as shown below.
3. Press the DISPLAY ACCESS [GROUP] button
repeatedly until the Group | In Master or
Group | Out Master page appears.
4. Use the cursor buttons to select parameters,
then use the Parameter wheel, [INC]/[DEC]
buttons, or [ENTER] button to set the param-
eters.
INPUT/OUTPUT FADER MASTER
When this check box is checked, you can set the master
levels for the Fader groups. The resultant Channel level
equals the corresponding Channel fader level plus the
Group Master level.
ALL NOMINAL
This button resets the master levels for all Fader groups to
nominal.
•ON/OFF
This turns each Input Fader group on or off. This func-
tion works like a VCA mute on an analog mixing console.
•Faders
These faders adjust the master levels of the Fader groups.
Fader knobs are highlighted when faders are set to 0.0 dB.
Press the [ENTER] button to set the currently-selected
fader to 0.0 dB.
You can also control the parameters from the channel
strips on the control surface as described below by using
the User Assignable Layer of the Remote Layers. See
page 110 for information on the User Assignable Layer.
[SEL] buttons
These buttons move the cursor on the In Master page or
Out Master page.
[SOLO] buttons
These buttons turn the Solo function of each Fader group
on and off. You can monitor all the channels in each Fader
group.
Channel Faders
The channel faders enable you to set the master level for
each Fader group.