Filter
Top Products
84 Remote Control
01V96i—Reference Manual
■ Configuring Macintosh Computers
1. Download the Yamaha Steinberg USB Driver
from the following URL.
http://www.yamahaproaudio.com/
2. Install the driver in your computer as
described in the installation guide included in
the downloaded file.
3. Connect the 01V96i TO HOST USB port to a
USB port on your Mac using a USB cable.
4. Make sure that the 01V96i is powered-on.
5. Launch Pro Tools.
6. Choose Peripherals from the Setups menu to
open the Peripherals window.
7. Double-click the MIDI Controllers tab.
8. Refer to the screen below to set the Type,
Receive From, Send To, and #Ch’s parame-
ters.
The 01V96i can emulate up to two MIDI controllers.
9. When you finish setting the parameters, close
the window.
Configuring the 01V96i
Follow the steps below to set up the 01V96i so that you can
remotely control Pro Tools from the 01V96i Remote Layer.
1. Press the DISPLAY ACCESS [DIO/SETUP] but-
ton repeatedly until the DIO/Setup |
MIDI/Host page appears.
2. Move the cursor to the first DAW parameter
box in the SPECIAL FUNCTIONS section, then
rotate the Parameter wheel to select USB as
the port.
3. Press [ENTER] to confirm the setting.
4. Move the cursor to the adjacent parameter
box (on the right), then rotate the Parameter
wheel to specify the port ID.
Tip: To control Pro Tools remotely, you need one port for
every eight audio channels.
Note: If you select an incorrect port, you will be unable to use
the Remote function. Be sure to match the port ID with that
specified in the Peripherals window in Pro Tools.