Yamaha 01V96i Music Mixer User Manual


 
90 Remote Control
01V96i—Reference Manual
Soloing Channels
To solo Pro Tools channels, press the [SOLO] buttons of the
desired channels. Grouped channels are soloed together, and
other channels are muted.
Press the [SOLO] buttons again to unsolo the channels.
Configuring Sends A–E as Pre or
Post
You can set Pro Tools channels for the selected Sends (A–E)
to pre or post.
1. Press the [F3] button to select Channel Dis-
play mode.
2. Press the FADER MODE [AUX 1]–[AUX 5] but-
tons to select the desired Sends (A–E).
3. To toggle between pre and post, move the
cursor to the parameter control on the dis-
play, then press [ENTER].
Pressing [ENTER] repeatedly toggles between pre and
post.
Setting Send Levels
You can adjust Pro Tools Send (A–E) send levels as follows.
1. Press the [F3] button to select Channel Dis-
play mode.
2. Press the AUX SELECT [AUX 1]–[AUX 5] but-
tons to select the desired Sends (A–E).
3. Move the cursor to the parameter control of
the channel for which you want to adjust the
Send level, then rotate the Parameter wheel.
You can set Send levels by operating the faders if faders,
[ON] buttons, and the [PAN] control are in Flip mode.
Refer to “Flip Mode” for more information.
Muting Sends A–E
You can mute Sends by pressing the [ON] buttons if faders,
[ON] buttons, and the [PAN] control are in Flip mode. Refer
to “Flip Mode” for more information.
Panning Sends A–E
You can pan channel signals sent to stereo Aux Sends by rotat-
ing the SELECTED CHANNEL [PAN] control if faders, [ON]
buttons, and the [PAN] control are in Flip mode. Refer to the
next section for more information.
Flip Mode
In Flip mode, you can use the faders, [ON] buttons, and the
[PAN] control to control send levels, pre/post positions, and
mute settings as shown in the following table.
1. Press the FADER MODE [HOME] button
repeatedly so that the button indicator
flashes.
The SELECT ASSIGN parameter on the display indicates
“FLIP.”
2. Press the FADER MODE [AUX 1]–[AUX 5] but-
tons to select the desired Aux Sends (A–E).
The button indicator of the selected send lights up.
3. Use the faders, [ON] buttons, and the [PAN]
control to control the currently-selected Aux
send.
For stereo Aux input channels, you can set the left and
right panpots individually. To do this, press the FADER
MODE [AUX 7] button repeatedly. When the button
indicator is lit continuously, you can set the left panpot.
When the button indicator is flashing, you can set the
right panpot.
Assigning Plug-ins to Pro Tools
Channels
You can assign plug-ins to five inserts available for Pro Tools
channel strips as follows.
1. Press the [F2] button to select Insert Display
mode.
2. Press the FADER MODE [AUX 8] button.
The [AUX 8] button indicator flashes. You can now select
a channel to which you want to insert plug-ins.
3. Press the [SEL] button of each desired chan-
nel.
4. Make sure that the INSERT/PARAM button
(
1) is selected in the INSERT ASSIGN/EDIT
section.
Control Normal mode Flip Mode
Faders Channel level AUX Send level
[ON] buttons Channel mute AUX Send mute
[PAN] control Channel pan AUX Send pan