Filter
Top Products
CVP-509/505/503/501 Owner’s Manual 113
3
CVP-509/505: Keyboard Stand Assembly
8 Connect the pedal cord.
9 Attach G using two screws for the cover.
10 Set the voltage selector and connect the
power cord.
Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the selec-
tor for 110V, 127V, 220V or 240V main voltages, use a “minus”
screwdriver to rotate the selector dial so that the correct voltage
for your region appears next to the pointer on the panel. The volt-
age selector is set at 240V when the unit is initially shipped. After
the proper voltage has been selected, connect the AC power cord
to the AC INLET and an AC wall outlet. A plug adaptor may be
also provided in some areas to match the pin configuration of the
AC wall outlets in your area.
11 Set the adjuster.
Rotate the adjuster until it comes in firm contact with the floor
surface.
WARNING
An improper voltage setting can cause serious damage to the instrument
or result in improper operation.
DD
E
1 Insert the pedal cord plug into the
pedal connector.
Insert the plug with the arrow-printed side
facing front (toward the keyboard side). If
the plug will not go in easily, do not force
it. Double-check the orientation of the
plug, then try again.
2 Align the pedal cord into the
groove on the rear leg, and install
the plastic cover onto the groove.
Be careful not to insert the cover’s
attachment strip between the groove
wall and the leg.
Pass the pedal cord
between D and E.
GG
A
(the bottom of the right side as
seen from the front)
After completing the assembly, please check
the following.
• Are there any parts left over?
→ Review the assembly procedure and correct any errors.
• Is the instrument clear of doors and other movable fix-
tures?
→ Move the instrument to an appropriate location.
• Does the instrument make a rattling noise when you
shake it?
→ Tighten all screws.
• Does the pedal box rattle or give way when you step on
the pedals?
→ Turn the adjuster so that it is set firmly against the floor.
• Are the pedal and power cords inserted securely into the
sockets?
If the main unit creaks or is otherwise unsteady when you play
on the keyboard, refer to the assembly diagrams and retighten
all screws.
When moving the instrument after assembly, always hold the bottom
of the main unit.
CAUTION
Do not hold the key cover or top portion. Improper handling can result in dam-
age to the instrument or personal injury.
Do not hold here.
Hold here.