Filter
Top Products
Reference Accessory CD-ROM Installation Guide
86 DGX-505/305 Owner’s Manual
Installing the driver on Windows 98/Me
1 Start the computer.
2 Insert the supplied CD-ROM into the CD-
ROM drive. A start window will appear auto-
matically. Close the window.
3 First, make sure the POWER switch on the
instrument is set to OFF, then use a USB
cable to connect the USB terminal of the
computer to the USB connector of the
instrument. When the instrument is turned
on, the computer automatically displays the
“Add New Hardware Wizard.” If the Add New
Hardware Wizard does not appear, click
“Add New Hardware” in the Control Panel.
For Windows Me users, check the radio button to the
left of “Automatic search for a better driver (Recom-
mended)” and click [Next]. The system automati-
cally starts searching and installing the driver.
Proceed to Step 8. If the system does not detect the
driver, select “Specify the location of the driver
(Advanced)” and specify the CD-ROM drive’s
“USBdrv_” folder to install the driver and click
[Next]. Execute the installation by following the
onscreen instructions and proceed to Step 8.
4 Click [Next].
The window enables you to select the search
method.
5 Check the radio button to the left of “Search
for the best driver for your device. (Recom-
mended).” Click [Next].
The window enables you to select a location in
which to install the driver.
6 Check the “Specify a location” box, click
“Browse..”, then specify the USBdrv direc-
tory of the CD-ROM drive (such as
D:\USBdrv_\) and continue the installation.
7 When the system detects the driver on the
CD-ROM and is ready for installation, it is
shown as a message on the screen. Make
sure that the “YAMAHA USB MIDI Driver” is
listed, and click [Next]. The system starts
the installation.
8 When installation is complete, a message
indicating so appears. Click [Finish].
The driver has been installed.
Installing the driver on Windows 2000
1 Start the computer and use the “Administra-
tor” account to log into Windows 2000.
2 Select [My Computer] ➔ [Control Panel] ➔
[System] ➔ [Hardware] ➔ [Driver Signing] ➔
[File Signature Verification], and check the
radio button to the left of “Ignore — Install
all files, regardless of file signature” and
click [OK].
3 Insert the supplied CD-ROM into the CD-
ROM drive. A start window will appear auto-
matically. Close the window.
4 First, make sure the POWER switch on the
instrument is set to OFF, then use a USB
cable to connect the USB connector of the
computer to the USB connector of the
instrument. When the instrument is turned
on, the computer automatically displays the
“Found New Hardware Wizard.” Click [Next].
5 Check the radio button to the left of “Search
for a suitable driver for my device. (Recom-
mended).” Click [Next].
The window that appears enables you to select a
location in which to install the driver.
6 Check the “CD-ROM drives” box and
uncheck all other items. Click [Next].
7 When the installation is complete, the sys-
tem displays “Completing the Found New
Hardware Wizard.” Click [Finish].
8 Restart the computer.
The driver has been installed.
• If you are using Windows Me, skip Step 4 – 7.
NOTE
• Some computers may take about ten seconds to show this screen
after the installation is complete.
NOTE
• The system may ask you to insert a Windows CD-ROM while it
checks for the driver. Specify the “USBdrv2k_” directory of the CD-
ROM drive (such as D:\USBdrv2k_\) and continue the installation.
NOTE
• Some computers may take about ten seconds to show this screen
after the installation is complete.
NOTE