Filter
Top Products
DGX-505/305 Owner’s Manual 93
Keyboard Stand Assembly (DGX-505 Only)
The parts shown in the “Assembly Parts” illustration will be used. Follow the assembly instructions and select the parts as
needed.
z Attach the stand bases.
Making sure that the boards are facing the proper direc-
tion (the holes should face inside). The left and right side
boards are the same shape. Insert the joint connectors w
into the holes as shown. The joint connectors have been
installed properly if you can see a plus mark on the con-
nector.
Attach the stand bases to the rear of the side boards,
using the 6 x 70 mm round head screws q. The left and
right stand bases are the same shape, and there is no differ-
ence between their front-to-back orientation. If you have
trouble screwing in the screws, use a screwdriver to rotate
the joint connectors to the appropriate position – the →
mark on the joint connectors indicates the location of the
screw hole.
Have a phillips-head (+) screwdriver ready.
Read these cautions carefully before you assemble or use the keyboard stand.
These cautions are to promote safe use of the stand and to prevent injury and damage
from occurring to you and others. By following these cautions carefully, your keyboard
stand will provide you with safe and prolonged use.
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please
assemble in accordance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated above. Use of incorrect screws can cause dam-
age.
• Use the stand after assembly is complete. An uncompleted stand may overturn or the keyboard
may drop.
•Always place the stand on a flat, stable surface. Placing the stand on uneven surfaces may cause it
to become unstable or overturn, the keyboard to drop, or injury.
• Do not use the stand for anything other than its designed purpose. Placing other objects on the
stand may result in the object dropping or the stand overturning.
• Do not apply excessive force to the keyboard as it may cause the stand to overturn or the keyboard
to drop.
• Make sure the stand is sturdy and safe, and all screws have been tight and firm before use. If not,
the stand may overturn, the keyboard may drop, or may result in injury to the user.
•To disassemble, reverse the assembly sequence given below.
CAUTION
q 6 x 70 mm round head
screws (4 pcs.)
Side
boards
Stand
bases
Back board
w Joint connectors (4 pcs.)
e 6 x 30 mm round head screws
(4 pcs.)
r 5 x 16 mm round head
screws (4 pcs.)
Assembly Parts (DGX-505 only)
1
w Joint connectors
q 6 x 70 mm round
head screws