Yamaha EX7 Electronic Keyboard User Manual


 
119
Voice Mode
[F8]: EG (Filter Envelope Generator)
Sets the FEG for the AN Element. You can control the
change in the timbre of the sound over time, from
when the key is played until it is released. This is
effective for VCF 1/2 filters.
Time K.Follow (Time KeyFollow)
Sets the Time Key Follow for the AN Element. This
Time Key Follow function adjusts the speed of the
change in timbre over time according to the note
played on the keyboard. The lower the note that is
played on the keyboard, the slower the change in
time becomes, whereas the higher the note played on
the keyboard, the faster the change in time becomes.
Negative values will produce the opposite effect.
Settings: –64~+63
Attack Time
Sets the amount of time from when the note is
played to the maximum cutoff frequency level.
Settings: 0~127
Decay Time
Sets the amount of decay time from the maximum
cutoff frequency level to the sustain level.
Settings: 0~127
Sustain Level
After passing through the Decay Time, this sets the
sustain level which the cutoff frequency maintains as
long as the key is held (key on).
Settings: 0~127
Slower
Faster
Higher range
Lower range
+63
+40
–40
Release Time
Sets the amount of time it takes for the signal to
reach the initial “0” value, after releasing the key.
Settings: 0~127
[F5]: AMP (Amplitude)
When an AN Element is selected, there are three types
of menus available.
[F6]: PARAM (Parameters)
[F7]: MIX
[F8]: EG (Envelope Generator)
[F6]: PARAM (Parameters)
Available settings are the same as for the AWM
Element (see page 96).
[F7]: MIX
Determines the settings related to the volume of VCO1
and VCO2. You can control the balance (mix) of the
VCO1/2, Noise and the Ring Modulator signal levels.
Block Diagram
VCO1 Level
Sets the signal level of the wave sent from VCO1 to
the mixer. When you do not want to apply the VCO1
signal, set the level to “0.”
Settings: 0~127
MIXER
VCO2
VCF
VCO1
HPF
VCA
NOISE
Feed Back
RING
MOD
Voice/E.qx 5/21/98 11:31 AM Page 119