Filter
Top Products
129
Voice Mode
■ Freq (Frequency)
Sets the central frequency for the Sample & Hold
LFO filter modulation.
❏ Settings: 0~127
■ Freq K.Flw(Frequency KeyFollow)
Sets the KeyFollow for the filter modulation central
frequency. This KeyFollow function controls the
change of the central frequency in accordance with
the notes played on the keyboard. When set to a
positive value, the higher the note played on the
keyboard, the higher the central frequency becomes.
When a negative value is set, the lower the note
played, the higher the central frequency becomes.
❏ Settings: –15~0~+15
■ Resonance
Sets the strength of the filter resonance. This setting
determines the amount of resonance boost near the
central frequency set in Freq.
❏ Settings: 0~63
■ Freq Mod (Frequency Modulation)
Sets the depth of the filter modulation. The larger
the value, the greater the degree of change in the
central frequency. A setting of “0” produces no
effect.
❏ Settings: 0~63
■ Mod Speed (Modulation Speed)
Sets the speed of change for the Sample & Hold LFO
filter modulation. The larger the value, the faster the
change becomes. This let’s you get a sound where
the water appears to be moving rapidly.
❏ Settings: 2~200
■ Mod Smooth (Modulation Smooth)
Sets the smoothness of the Sample & Hold LFO filter
modulation. The larger the value, the greater the
degree of the viscosity becomes.
❏ Settings: 0~63
■ Feedback
Sets the strength of the resonance for the resonating
strings. The larger the value, the more the pitch
becomes articulate. However, if the value is increased
too much, the atmosphere of water will disappear.
❏ Settings: 0~63
■ Feedback Kf (Feedback KeyFollow)
Sets the KeyFollow for the Feedback. Feedback
KeyFollow function controls the change in the
resonance (for the resonating strings) in accordance
with the notes played on the keyboard. When set to
a positive value, the higher the note played on the
keyboard, the greater the change in resonance
becomes. When a negative value is set, the lower the
note played, the greater the change in resonance
becomes.
❏ Settings: –15~0~+15
■ High Dump
Sets the amount of decay in the higher frequencies
for the resonating strings. The larger the value, the
larger the higher frequency decay becomes. This
setting corresponds to the the simulation that
determines the material of the strings.
❏ Settings: 0~15
■ High Dump Kf (High Dump KeyFollow)
Sets the KeyFollow for the amount of the higher
frequency decay. This KeyFollow function controls
the change in the amount of the higher frequency
decay for the resonating strings in accordance with
the notes played on the keyboard. When set to a
positive value, the higher the note played on the
keyboard, the greater the change becomes. When a
negative value is set, the lower the note played, the
greater the change becomes.
❏ Settings: –15~0~+15
■ ReleaseTime
Sets the release time (the time from note-off until the
sound ends).
❏ Settings: 0~48
■ HPF (High Pass Filter)
Sets the cutoff frequency which cuts the lower range
of the water sound.
❏ Settings: 0~127
■ Wet Level
Sets the output level for the water sound. You can
adjust the FDSP (Water) balance by combining this
parameter and the Dry Level below. A setting of “0”
produces no output. Settings with the negative
values reverse the phase of the waveform.
❏ Settings: –64~0~+63
Voice/E.qx 5/21/98 11:31 AM Page 129