Filter
Top Products
138
Voice Mode
■ Wet Gain
Sets the maximum output level for the modulated
signal.
❏ Settings: 0~127
■ Wet Vel (Wet Level Velocity)
Sets the velocity sensitivity for the Wet Level. This
lets you control the output level of the modulated
signal by the strength at which you play the
keyboard.
❏ Settings: –64~0~+63
■ Wet Level
Sets the output level for the signal that is affected by
the Tornado. You can adjust the FDSP (Tornado)
balance by combining this parameter and the Dry
Level below.
❏ Settings: 0~127
■ Dry Level
Sets the output level for the original input signal.
❏ Settings: 0~127
■ Pan
The same as the one in the EP Pickup. See page 126
for information.
09: Ring Mod (Ring Modulator)
Ring Mod modulates the original input signal (as
carrier) using the modulators of the amplitude
modulation (AM). When set to a maximum (200%) of
modulation depth, being equivalent to a conventional
“ring modulator,” two frequency components are
generated: the one as a sum frequency of the carrier
and modulator signals, and the other as a difference of
them. As the modulation depth is decreased, the
intensity of the carrier frequency components is more
dominant in output. When set to 0%, only the original
input signal is output. Even though this program uses a
sine wave as the modulation wave, the Ring Mod
provides with more complicated harmonics because
two AM modulators (main and sub) can be used.
The underlined items in the diagram are available as the
Destination parameters for the FDSP Controller set (page
141).
■ Pitch Coarse
Sets the pitch of the main modulator’s wave in
semitones. A setting of “0” produces a pitch of C3 =
261.63Hz.
❏ Settings: –64~0 (C3)~+63
■ Pitch Fine
Adjusts the pitch of the main modulator’s wave.
❏ Settings: –50~0~+50
■ Sub Pitch
Sets the pitch of the sub modulator’s wave in ca.
semitones, at a ratio to the main modulator’s wave
pitch. A setting of “0” produces a frequency of “0,”
while when set to “127,” the pitch of the sub
modulator wave becomes equal to the one of the
main modulator’s wave pitch.
❏ Settings: 0~127
■ K.Flw Coarse (KeyFollow Coarse)
Sets the KeyFollow for the Pitch Coarse. The
KeyFollow Coarse function controls the pitch of the
modulation wave form in accordance with the notes
played on the keyboard. When set to “+32,” the
KeyFollow functions at 100% and the change in the
pitch of the modulation wave moves in proportion to
the pitch played on the keyboard. When set to a
value of “0” the pitch of the modulation wave is
fixed.
❏ Settings: –32~0~+64
■ K.Flw Fine (KeyFollow Fine)
Sets the KeyFollow for the Pitch Fine to finely
adjusts the KeyFollow Coarse function.
❏ Settings: –64~0~+63
Main
OSC
Sub
OSC
PEG depth
RingMod RingMod
EG
MainEGDepth SubEGDepth
Main freq. -coarse/
Sub freq. -coarse/fine
(fixed)
Input
Output
EG mode
Time
Sub pitch
Pitch
coarse/fine
ModDepth
ModDepth
fine (fixed)
Main Sub
Voice/E.qx 5/21/98 11:31 AM Page 138