Filter
Top Products
[F7]: MIX
Sets the mix (output), pan, and other settings related to
pitch for each sample which make up a wave. Settings
can be made for each layer.
The Layer and Sample Bank/Number parameters here are
the same as those in the SMPL display. For more
information on these parameters, see page 152.
The Zone Graphical Display to the left of the screen shows
the keyboard/velocity range of the currently selected layer.
For more information on the Zone Graphical Display, see
below.
■ Lvl (Level)
Sets the output level for each sample. This setting
adjusts the output balance for the samples/layers.
❏ Settings: 0~127
■ Pan
Sets the left or right positioning of each sample in
the stereo spectrum. This setting adjusts the
positioning of where each sample appears in the
stereo spectrum.
❏ Settings: L64 (far left)~cnt (center)~R63 (far right)
■ Freq Mode (Frequency Mode)
Sets the pitch for each sample either to semitones for
each key (ratio), or to the same pitch for the entire
keyboard (fixed).
❏ Settings: ratio, fixed
■ Coar (Coarse Tune)
Adjusts the pitch of the sample for each layer in
semitones.
❏ Settings: –64~0~+63
■ Fine (Fine Tune)
Finely adjusts the pitch of the sample for each layer.
❏ Settings: –64~0~+63
[F8]: ZONE
Sets the zone of each sample (the keyboard and velocity
ranges within which the sounds are played). A
different zone can be set for each sample/layer.
The Layer and Sample Bank/Number parameters here are
the same as those in the SMPL display. For more
information on these parameters, see page 152.
■ Note Limit Low
Sets the lowest note of the zone on the keyboard, for
each sample.
❏ Settings: C-2~G8
The lowest note set here and the note set in Note Limit
High determine the range where sound will be
produced for the selected sample.
■ Note Limit High
Sets the highest note of the zone on the keyboard,
for each sample.
❏ Settings: C-2~G8
The Note Limit Low note can not be set higher than the
Note Limit High, and vice versa.
■ Vel Limit Low (Velocity Limit Low)
Sets the lowest velocity value of each sample that is
detected when the keyboard is played.
❏ Settings: 1~127
The lowest velocity value set here and the value set in
Vel Limit High determine the range of velocity for the
selected sample.
■ Vel Limit High (Velocity Limit High)
Sets the highest velocity value of each sample that is
detected when the keyboard is played.
❏ Settings: 1~127
The Vel Limit Low value can not be set higher than the
Vel Limit High. Also vice versa, the Vel Limit High
value can not be set lower than the Vel Limit Low.
153
Voice Mode
Voice/E.qx 5/21/98 11:31 AM Page 153