Filter
Top Products
171
Performance Mode
Knob
■ Knob To TG (Knob To Tone Generator)
When making bank/program changes, this sets
whether or not the preset values for Knobs 1-6 are
sent to the tone generator. When set to “on” the
messages are sent, and when set to “off” they are not
sent.
❏ Settings: off, on
■ Knob To MIDI
When making bank/program changes, this sets
whether or not the preset values for Knobs 1-6 are
sent to an external MIDI device. When set to “on”
the messages are sent, and when set to “off” they are
not sent.
❏ Settings: off, on
■ InitVal KN1~6 (Initial Values KN1~6)
Sets the control change preset values that are sent by
the Knobs 1-6.
❏ Settings: Each of the Knobs 1-6 can be set from 0~127
The contents of the control change for each controller
and Knobs 1-6 are designated in the CTRL screen.
Auditioning the Settings Done in the Preset Menu
The EX will output the parameter settings done in the
preset menu when you press [ENTER] key while
holding [SHIFT] key. You can audition the results.
[F3]: MLT (Multi)
Setting the parameters for each part in each
Performances is achieved in the chart. Various parts
can be displayed simultaneously and each can be
edited. Available parameters are the same as for those
explained for the PART screen, page 164.
When the MLT menu is selected with [F3], the
following five types of category menus are displayed.
You can easily scroll through the list and select the
desired parameter using the [F4]~[F8] keys.
[F4]: MIX (Settings related to MIX)
[F5]: LYR (Settings related to Layers)
[F6]: SOUND (Settings related to Sound)
[F7]: CTRL (Settings related to the Controllers)
[F8]: PRE (Settings related to the Presets)
Each time [F3] is pressed the Part section changes to
show the Part 1~4, Part 5~10 and Part 11~16,
alternately.
“Lyr” column allows you to adjust the overall settings
(such as volume and pan) for the parts which “Layer
Switches” (LYR menu) are turned on. You can adjust
each setting with the relative values among the balance
of the parts kept.
In the MLT screen, you can directly select the Part that
you want to edit by using the PART keys 1-16 on the panel
(EX5/7).
The available parameters are listed below. For
information about each parameter’s contents and
available values, see the explanation for the PART
screen (page 164).
F3
F3
F3
Lyr~Part 1~4
Part 5~10
Part 11~16
Performance/E/qx 5/21/98 11:35 AM Page 171