Yamaha EX7 Electronic Keyboard User Manual


 
286
Appendix
How to Install the EXIDO1
in the EX5R
Necessary Items
EXIDO1 (Individual Output Board) x 1
Flat cable x 1 (included in the EXIDO1 package)
Installation
You can install the EXIDO1 after removing the main
unit top cover. For more information on removing the
main unit top cover, see above.
When installing the optional board (from when you
remove the EX5R top cover to when the cover is
replaced securely) all operations must be done with
the power cord disconnected.
1Remove the two screws from the EXIDO1/EXDGO1
opening cover (hold the cover from inside the EX5R
as you remove the cover). The two screws will be
used again when securing the EXIDO1. Be careful
not to lose them.
After you take off the cover, do not leave it inside the
EX5R and put it in a safe place.
2Remove the EXIDO1/EXDGO1 power cable (1 red
and 4 white, 5 pin cable) from the hook-shaped
bundle tie in the EX5R. Make sure not to catch the
cable on any other cables or the circuit board while
removing it from the hook-shaped bundle tie and set
it aside. Place the remaining cable back into the
bundle tie.
Power cable
Opening cover
3As shown in the diagram, bend the flat cable to the
specified dimensions.
4Connect the flat cable to the EXIDO1.
5Connect the EXIDO1/EXDGO1 power cable that
was set aside in step 2 to the EXIDO1 connector. Be
careful not to connect the connector in the wrong
direction.
6Check the location of the DGO/IDO connector in
the EX5R and connect the EXIDO1 and the EX5R
with the flat cable. When facing the rear panel, the
DGO/IDO connector is on the right side as shown in
the illustration. “DGO/IDO” is printed on the panel.
DGO/IDO
Rear
Line up the red cable
with the mark .
Cable is connected. (Rear)
Make sure that
the connector is
facing the correct
direction.
20mm10mm50mm
20mm
Blue marking
Indicates that the cable
should be folded upwards
at this line.
Indicates that the cable
should be folded downwards
at this line.
50mm
Option/E/qx 5/21/98 11:58 AM Page 286