Filter
Top Products
148
Voice Mode
[F8]: EFCT (Effects)
Sets the effects for the drum elements. The signals
from the maximum of 128 drum elements can be
connected either to Insertion Effect 1 or 2, then sent to
the Reverb/Chorus unit. “InsRev” and “InsCho”
parameters added to the Type screen allow you to
emphasize the effect for specific drum elements. The
other parameters are the same as those for AWM
elements on page 105.
[F4]: TYPE
■ Ins→Rev
Sets the send level of the signal output from the
Insertion unit and sent to the Reverb unit. By
passing specific elements through Insertion effect
and setting the output level here, you can make
different setting for the amount of Reverb applied to
the specific elements.
❏ Settings: 0~127
■ Ins→Cho
Sets the send level of the signal output from the
Insertion unit and sent to the Chorus unit. By
passing specific elements through Insertion effect
and setting the output level here, you can make
different setting for the amount of Chorus applied to
the specific elements.
❏ Settings: 0~127
You can determine whether or not each effect is applied
to each element in the Mix screen (page 145).
Voice Job Mode
These jobs let you initialize or recall voices that are
created in Voice Edit mode.
Press [JOB] key on the panel while in Voice mode to
enter Voice Job mode. When you enter the Voice Job
mode, the following menu will be displayed. There are
three types of jobs in Voice Job mode. Press [F1]
(INIT), [F2] (RECL), or [F3] (COPY) to select a job.
It is necessary to first select the voice that will be
initialized or recalled, before entering the Voice Job mode.
[F1]: INIT (Initialize)
[F2]: RECL (Recall)
[F3]: COPY (Copy)
Steps for Executing a Job
1 When in the Voice Play mode, select the voice
number you want to execute job operation.
2Press [JOB] to enter the Voice Job mode.
3Press [F1] (INIT), [F2] (RECL), or [F3] (COPY) to
select a job to execute. The selected job screen will
be displayed.
You can also select each job by moving the cursor to the
desired job name on the screen and pressing [ENTER].
4Move the cursor to a parameter and use the
[INC]/[DEC], Data Dial, numeric keypad, or the
Knobs 1~6 to set values.
This operation is not necessary for Initialize and Recall.
F1 F2 F3
Voice/E.qx 5/21/98 11:31 AM Page 148