Filter
Top Products
218
Song Mode
❏ Settings: –99~+0~+99
8. Shift Event
This job replaces all occurrences of a specific event
type (within the designated range of the specified
sequence track) with some other designated event type.
For example, you can use this function to change
breath controller data into channel aftertouch events.
■ Track
Sets the track where Shift Event will be executed.
❏ Settings: 1~16(Sequence tracks 1~16)
■ Measure
Sets the measure range (beginning measure to the
end measure) where Shift Event is executed.
❏ Settings: 001~999 (for the beginning measure and the
end measure)
■ Src Event (Source Event)
Selects the source that will be changed.
❏ Settings: Control Change, Ch After Touch (Channel After
Touch), Pitch Bend, Note (Note#: note
numbers), Note (Vel: velocity values of each
note)
Original Data
64
(Vel)
(Vel)
(Vel)
64 64 6464 64
64 54 44 2434 14
94 114
Range=+40(001: 1~003: 1)
64 74 84 104
Range=–40(001: 1~003: 1)
■ Dst Event (Destination Event)
Sets the destination event that the source event is
changed to.
❏ Settings: Control Change, Ch After Touch (Channel After
Touch), Pitch Bend, Note (Note#: the data
change of the source event will be replaced with
note numbers with the fixed velocity 64 and
fixed gate time 108), Note (Vel: the data change
of the source event will be replaced with
velocities with the fixed pitch C3 and fixed gate
time 108).
[F7]: UNDO/REDO
Undo/Redo function is assigned to [F7]. Undo cancels
the changes you made in your most recent record, edit,
or job operation, restoring the data to its previous state.
Redo, which becomes available only after you execute
an Undo, cancels Undo operation and restores the
changes. When you inadvertently execute a job, make a
mistake while recording or editing, this job is
convenient for restoring important data that would
otherwise be lost.
Undo/Redo is always effective after a record, edit, and
job operation. As soon as you execute an Undo, the job
name changes to REDO. UNDO and REDO alternately
appear after Undo/Redo operation. If data is not
changed, Undo/Redo will not become effective.
Steps for Executing Undo/Redo
1Press [F7] (UNDO/REDO and the UNDO/REDO
screen will be displayed.
UNDO/REDO:
Available operation, UNDO or REDO, is displayed.
The target of Undo/Redo:
The target of Undo/Redo function will be displayed, that is,
the most recent record, edit, or job operation name.
2Press [ENTER] to execute Undo/Redo. “Completed!”
will appear in the screen indicating that the
cancellation was executed and the previous screen
will be displayed.
If [F7] (UNDO) is pressed without any previous operation
taking place, “Undefined job” will be displayed and Undo
cannot executed.
UNDO/REDO The target of Undo/Redo
Song/E/qx 5/21/98 11:41 AM Page 218