Filter
Top Products
Arpeggio Mode
254
4. Thin Out
This job removes every other occurrence of a
designated non-note event from the specified track
range. The purpose is to reduce the amount of data and
free up additional memory.
When the interval of each event is larger than 60 clocks,
data is not removed.
■ Track
Sets the track where Thin Out will be executed.
❏ Settings: 1~4
■ Measure
Sets the measure range (beginning measure to the
end measure) where Thin Out is executed.
❏ Settings: 001~999 (for the beginning measure and the
end measure)
■ Events
Sets the type of event that will be reduced. When
“Control Change” is selected, a setting parameter
will be added, and the control number can be
designated there.
❏ Settings: Pitch Bend, Control Change (Control numbers
range from 000~127), Ch After Touch (Channel
After Touch), PolyAfter Touch (Polyphonic
After Touch)
5. Extract
This job moves all instances of specific data from a
designated range of a sequence track to the same range
on a different sequence track. Following the operation,
the targeted events no longer exist in the source track.
If data already existed at the destination, the extracted
data and existing data are mixed.
■ Track
Selects the track that will be extracted from (Extract
source) and the track that will be copied to (Extract
destination).
❏ Settings:
Extract source: 1~4
Extract destination: 1~4
■ Measure
Sets the measure range (the beginning measure and
the end measure) where Extract is executed.
❏ Settings: 01~16 (for the beginning measure and the end
measure)
■ Events
Sets the type of event that will be extracted.
When an event other than “Sys. Exclusive” is
selected, additional parameters for the event range
will be added, and you can designate the range.
❏ Settings: Note, Program Change, Pitch Bend, Control
Change, Ch After Touch (Channel After Touch) ,
PolyAfterTouch (Polyphonic After Touch),
Sys.Exclusive(System Exclusive)
■ Event Range
Sets the range you want to extract the event. The
unit of the value differs depending on the selected
event.
❏ Note: Key=1~16, Oct=–4~+3
❏Program Change, Control Change (Control number),
Ch After Touch, PolyAfterTouch: 0~127
❏ Pitch Bend: –8192~+8192
For the information about Key number and Octave
number see page 240.
Arpeggio/E/qx 5/21/98 11:51 AM Page 254