Yamaha QY70 Recording Equipment User Manual


 
REVERB DEPTH 4
PITCH BEND CHANGE 0 (center)
MODULATION 0 (off)
EXPRESSION 127 (maximum)
SUSTAIN SWITCH 0 (off)
SOSTENUTO SWITCH 0 (off)
RPN Un-set status.
PORTAMENT CONTROL reset
MIDI MASTER VOLUME 127 (maximum)
PITCH BEND SENSITIBITY 02 (2 semitones)
FINE TUNING 0
COURSE TUNING 0
(3-6-2) UNIVERSAL REALTIME MESSAGE
(3-6-2-1) MIDI MASTER VOLUME
F0H 7FH 7FH 04H 01H llH mmH F7H
Modifies the MASTER VOLUME value.
The value of mm is used as the MIDI Master Volume (the ll value is ignored).
(3-6-3) PARAMETER CHANGE
(3-6-3-1) MIDI MASTER TUNING
F0H 43H 1nH 27H 30H 00H 00H mmH llH ccH F7H
Modifies the MASTER TUNE value.
The values of mm and ll are used as the MIDI Master Tuning.
(n and cc values are ignored.)
T = M*200/256-100
Where T : actual tuning value (-99 — +99)
M: a one-byte value with MSB of ”mm“ bits 0-3, and LSB of ”ll“ bits 0-3.
(3-6-3-2) XG SYSTEM ON
11110000 F0 Exclusive status
01000011 43 YAMAHA ID
0001nnnn 1n device Number
01001100 4C Model ID
0aaaaaaa 00 Address High
0aaaaaaa 00 Address Mid
0aaaaaaa 7E Address Low
00000000 00 Data
11110111 F7 End of Exclusive
When On is received, the SYSTEM MODE will be changed to XG.
Since approximately 50 ms is required in order to execute this message, an appropriate interval must be
allowed before the next message.
Controllers will be reset, and all Multi Part and Effect data of the attached table, together with the values
of all data of All System that are noted as (XG), will be reset to the Default values.
(3-6-3-3) XG PARMETER CHANGE
11110000 F0 Exclusive status
01000011 43 YAMAHA ID
0001nnnn 1n device Number
01001100 4C Model ID
0aaaaaaa aaaaaaa Address High
0aaaaaaa aaaaaaa Address Mid
0aaaaaaa aaaaaaa Address Low
0ddddddd ddddddd Data
||
11110111 F7 End of Exclusive
M I D I D a t a F o r m a t
4747