Yamaha S30 Electronic Keyboard User Manual


 
105
Performance Mode
4Repeat steps 2 and 3 for each of the other Parts.
To avoid losing the settings, make sure you store the
Performance before exiting to another Mode or selecting
another Performance. Details about how to store
Performances are given on Page 124.
Reading the Displayed Settings
Screens 3 to 7 have the following functions.
1Parameter: shows the parameter settings
2Part: shows the currently selected Part
3Value: shows the setting for the currently
selected Part
4Bar graph: shows the settings for each Part as a
bar graph
Common (Layer Common)
PartPL (Plug-in Part)
Part01 ~ Part16 (Voice Parts 1 ~ 16)
5Layer Switch on/off: displays a “L” mark above
the bar graph for Parts which have their Layer
Switch set to “on.”
6Mute on/off: displays a “*” mark above the bar
graph for Parts which are muted. Press the
[ENTER] key to switch mute on/off for the
currently selected Part.
If a multitimbral Plug-in board is installed in Plug-in
Slot, PartPL (Plug-in Part) will no longer be
available. However, you will now be able to select
Part17 to Part32 (Voice Parts 17 to 32). A “
” mark
is displayed to the right of the bar graph, indicating
that there are more Parts available. If you select
Part17 to Part32, the bar graph shows the settings
for those Parts.
PFM Mlt) Volume L * 
Part01 127 ›
PFM Mlt) Volume 
Part17 127
Part17~Part32
PFM Mlt)NoteSft L * 
Part01 + 0 -__-_-_______________
PFM Mlt)ChoSend L * 
Part01 127 -__-_-_______________
PFM Mlt)RevSend L * 
Part01 127 -__-_-_______________
PFM Mlt) Pan L * 
Part01 L63 -__-_-_______________
PFM Mlt) Volume L * 
Part01 127____ ___________ ›
2 3 41
Common
5 6
PartPL PartP01 ~ 16
3rd Screen: PFM Mlt) Volume (Performance
Multi: Volume)
Set the output level (volume) of each Part.
Settings: 0 ~ 127
4th Screen: PFM Mlt) Pan (Performance Multi: Pan)
Set the stereo pan position for each Part.
Settings: L63 ~ C ~ R63
5th Screen: PFM Mlt) RevSend (Performance
Multi: Reverb Send)
For each Part, set the Send level of the signal sent
from Insertion Effect 1/2 (or the bypassed signal) to
the Reverb effect.
Settings: 0 ~ 127
6th Screen: PFM Mlt) ChoSend (Performance
Multi: Chorus Send)
For each Part, set the Send level of the signal sent
from Insertion Effect 1/2 (or the bypassed signal) to
the Chorus effect.
Settings: 0 ~ 127
7th Screen: PFM Mlt) NoteSft (Performance
Multi: Note Shift)
Set the amount (in semitones) by which the pitch of
each Part is offset. You can adjust the offset up or
down by up to two octaves.
Settings: -24 ~ 0 ~ +24
PFM Mlt)NoteSft L *
Part01 + 0
PFM Mlt)ChoSend L *
Part01 127
PFM Mlt)RevSend L * 
Part01 127
PFM Mlt) Pan L *
Part01 L63
PFM*Mlt) Volume L *
Part01 127