Filter
Top Products
107
Performance Mode
Tone Generator Mode: [MASTER KEYBOARD]
key LED off
The í Indicator
If you alter any parameters in Performance Edit Mode,
the í indicator will be displayed in the top left of the
screen. This gives a quick indication that the current
Performance has been modified but not yet stored.
Even if you exit to Performance Play Mode, the edited
settings for the current Performance will not be lost so
long as you do not select another Performance.
The í indicator will also be displayed in
Performance Play Mode.
The
í indicator will also be displayed in Voice Play
Mode if any Assignable knobs are used.
MIXíLevel) Com:>GE
Part01 Part:>MI
Edit indicator
ARP
MIDI OUT
TG
Part 1 to 16 Part PL
MIDI IN
MIDI channel
Octave
Transpose
Note Limit etc.
The “Compare” Function
Use this to listen to the difference between the
Performance with your edited settings and the same
Performance prior to editing.
1Press the [EDIT/COMPARE] key while in
Performance Edit Mode. The í indicator at the
top left of the screen will change to the î indicator
and the [EDIT/COMPARE] key LED will blink.
The Performance settings prior to editing will
temporarily be reinstated for comparison purposes.
Editing will not be possible while the “Compare”
function is enabled.
2Press the [EDIT] key again to disable the
“Compare” function and restore the settings for
your edited Performance.
Performance Store
The edited settings for the current Performance will
be lost if you exit to Performance Play Mode and then
select another Performance or Mode. To avoid losing
important data, you should always use Performance
Store to store your edited Performances after exiting
Performance Edit Mode. Details about the
Performance Store procedure are given on Page 124.
Details about the Edit Recall function are given on
Page 123.
When creating a new Performance from scratch, it is
useful, prior to editing, to clear the settings for the
current Performance using the Initialize Performance
function in Performance Job Mode (Page 123).
Common (Settings for all Parts)
Here we explain how to edit common settings for all
Parts in a Performance. There are six Menus available,
each of which consists of multiple pages.
• Common General
• Common Quick Edit
• Common Arpeggio
• Common Controller
• Common Master EQ
• Common Effect
MIXîLevel) Com:>GE
Part01 Part:>MI
“Compare” indicator