Filter
Top Products
133
Utility Mode
CTRL Assign1 (Controller Assign 1)
Use Knobs [C], [1] and [2] to assign Control Change
Numbers to the Breath Controller, Knob [1] and Knob
[2], respectively. The selected Control Change Name is
shown on the left of the display.
■ BC (Breath Controller)
Specify a Control Change Number for this
Assignable Controller. When MIDI information for
this Assignable Controller is received, the specified
Control Change is applied.
❏ Settings: 00 ~ 95 (see the separate Data List for details)
■ Knob1/2 (Knob [1]/[2])
Assign Control Change Numbers to Knobs [1] and
[2] on the front panel.
❏ Settings: 00 ~ 95 (see the separate Data List for details)
CTRL Assign2 (Controller Assign 2)
Use Knobs [C] and [1] to assign Control Change
Numbers to the Foot Controller and Ribbon Controller,
respectively. The selected function is shown on the left
of the display. Use Knob [2] to select the Ribbon
Controller Mode.
■ FC (Foot Controller)
Assign a Control Change Number to the Foot Controller.
The Foot Controller is connected to the FOOT
CONTROLLER connector on the rear panel (Page 13).
❏ Settings: 00 ~ 95 (see the separate Data List for details)
■ RB (Ribbon Controller)
Specify a Control Change Number for this Assignable
Controller. When MIDI information for this Assignable
Controller is received, the specified Control Change is
applied.
❏ Settings: 00 ~ 95 (see the separate Data List for details)
Details about Controller Assign settings in Performance
Mode are given on Page 111.
CTRL Assign2) FC RB
Vce [--------] 04 22
Control Change
Number
Control Change Name
CTRL Assign1) BC Knob1 Knob2
Vce [FootCtrl] 02 16 17
Control
Change Number
Control
Change Name
PLG (Plug-in) (if a Plug-in Board has been installed)
If you have a Plug-in Board installed, the following two
screens are available for setting its parameters.
However, the number of sub-screens and parameters will
vary depending on the type of Plug-in Board installed.
PLG MIDI (Plug-in MIDI)
PLG System (Plug-in System)
PLG MIDI (Plug-in MIDI)
Set the MIDI parameters of the Plug-in Board.
■ Clock
Select whether or not to transmit MIDI Clock
messages to the Plug-in Board.
❏ Settings: off, on
■ DevNo (Device Number)
Set the MIDI Device Number of the Plug-in Board.
This number must match the Device Number of the
external MIDI device when transmitting/receiving
bulk data, parameter changes or other system
exclusive messages to/from it.
❏ Settings: 1 ~ 16, all, off
PLG System (Plug-in System)
Set the system parameters for each Plug-in Board. Use
Knob [C]/[2] to change the parameter. The number of
screens and parameters will vary depending on the type
of Plug-in Board installed. In the following example, a
PLG150-AN Plug-in Board has been installed in the
Plug-in slot.
Part Assign (assignment) for a Single-Part Plug-in Board is
fixed as follows:
• Voice Mode: 1
• Performance Mode: 15
PLG System) Vel Curve Mrph CtrlNo
norm off
PLG MIDI) Clock DevNo
PLG150-AN on all