Filter
Top Products
DGX-630/YPG-635 Owner’s Manual 11
Setting Up
x Attach the stand bases.
Insert the joint connectors q into the stand boards as
shown. The joint connectors have been installed properly if
you can see the screw head on the connector.
Attach the stand bases to the bottom of the side boards,
using the screws w. The left and right stand bases are the
same shape, and there is no difference between their front-
to-back orientation. If you have trouble fastening the
screws, use a screwdriver to rotate the joint connectors so
that the connector holes are aligned with the screw holes
on the stand bases.
c Attach the back board.
Attach the back board, using the screws e. Check the
back-to-front orientation for the side boards. Make sure the
non-colored surface is facing down.
v Attach the support rail.
Spread the packing sheet on the floor. Place the instru-
ment on the sheet with the rear panel side on the bottom.
Align the support rail r into the groove on the bottom
of the instrument and attach the rail, using the screws t.
2
q Joint connectors
w 6 x 70 mm
roundhead screws
e 6 x 30 mm roundhead screw
3
4
t 4 x 45 mm
flathead
screws
r Support rail
• If you put the connectors in wrong direction and want to take them out,
tap around the holes on the boards.
NOTE
• Be careful not to drop the back board or touch the sharp metal fit-
tings.
CAUTION
• If you have purchased an optional pedal unit, attach the pedal unit
before proceeding to the next step. Refer to the instructions provided
with your pedal unit.
NOTE
• If you don’t have the packing sheet, use a thick blanket or other soft
material to protect the floor and the instrument.
NOTE