92 PDS • User’s Guide
5. GUI Operations
Multiple Unit Control UI
jìäíáéäÉ=råáí=`çåíêçä=rf
The Multiple Unit Control User Interface (UI) allows an operator to control multiple PDS
units on the same network via a web browser, without installing a separate control
application. After discovery and setup of the PDS units in the UI, one or more units can be
enabled to accept source changes or transitions. After this is done, selection of any input,
including Logo or initiation of a transition, will happen on the selected PDS units.
Use the following steps to setup and start using this UI to control multiple PDS units.
`çååÉÅíáçå=íç=íÜÉ=jìäíáéäÉ=råáí=`çåíêçä=rf
1. Ensure each PDS unit is connected to the network and configured with a proper
Ethernet IP address. Refer to the “Ethernet” section in chapter 4 for more
information.
2. Access the PDS Home Page on one of the units. Refer to “GUI Connection and
Launch” on page 88.
3. Select “Multiple Unit Control UI” from the PDS Home Page. The PDS Multiple Unit
Control UI will appear.
Figure 5-6. PDS Multiple Unit Control User Interface (UI)
